*deleted*
Refer to next post.
This post has been edited by mmohdnor: Nov 16 2017, 12:20 AM
TP-LINK Malaysia Official Thread, Technical Enquiries and Support
TP-LINK Malaysia Official Thread, Technical Enquiries and Support
|
|
Nov 16 2017, 12:17 AM
Return to original view | Post
#1
|
![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
1,021 posts Joined: Aug 2006 From: Penang Island, Alor Star |
*deleted*
Refer to next post. This post has been edited by mmohdnor: Nov 16 2017, 12:20 AM |
|
|
Nov 16 2017, 12:19 AM
Return to original view | Post
#2
|
![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
1,021 posts Joined: Aug 2006 From: Penang Island, Alor Star |
QUOTE(arrsoo @ Nov 10 2017, 05:12 PM) Hi guys, Hi guys, I'm using Archer C5 now and just got upgraded from unifi 30Mbps to 50Mbps. since then, the speed has not been consistence. Before that I can easily get 30Mbps easily on both 2.4G and 5G but ever since upgraded, I only managed to get 20Mbps for 2.4G and 30Mbps for 5G even though the signal bar shows 4 bar for 2.4G and 1 bar for 5G. how come like that as 2.4G is showing a stronger 4 bar signal compared with 1 bar signal/5G yet the speed for 2.4G is so slow? I have disabled both the IPV6 and Bandwidth control but that doesn't seems to help... Not sure if this is related. but looks like it. Just got upgraded from 30mbps to 50mbps too recently. I was using TL-WR841HP V1 before this. Wanted to try AC wifi for my new 50mbps line so I bought the Archer C60 V2 AC1350 and a AC600 wifi receiver Archer T2U. But after a few days testing, seems like my C60 can't give 40Mbps+ over wifi on both 2.4GHz or 5GHz. Most of the time it hovers around 30Mbps or so. With LAN cable, I can get at least 40-45Mbps on both my routers C60 & WR841HP. But not on Wifi, it seems stuck / capped around 30mbps, where mostly I get just 25-28Mbps on wifi. Also tested with my other devices with wifi AC smartphones in the house. (A 2-storey terrace) Some suggested to disable QoS, but i can't. My router won't work if I do not enable Unifi IPTV. How to disable the QoS? The checkbox is greyed out if I choose Unifi IPTV enable for C50 V2 firmware. It says QoS and IPTV can't be enabled together at the same time. Should I use custom settings for IPTV and then enable the QoS? What are the numbers to use for IPTV? In the end, just using the C60 as repeater to my old WR841HP ..*sigh* This post has been edited by mmohdnor: Nov 16 2017, 12:34 AM |
| Change to: | 0.1059sec
0.78
7 queries
GZIP Disabled
Time is now: 29th November 2025 - 08:29 AM |