The Hill Start Assist is turn on by default. So far tested on multi story car park no issue. You have to fully break/stop your car then when release the break it won't slip backwards. However remember Hill Start Assist is not to be use as break, as soon as you release the break try to step on the gas as soon as you can. If you need to hold the car for a longer position, fully press the break.

[attachmentid=8463060]

Oh i see thanks. Will have to go and test again. Can't remember if i press the brakes the last time...

If I didn't recall wrong, the hill assist thingy only help for few seconds (like 2-5 seconds)
After that it will release, so be aware that it is not holding for long time and the car may move backwards or forward lo

List of LYN Owners
Please add me @y4ng

16

klguy

Ampang

1.3 Advance

Ocean Blue

Auto

Thanks

Please add me @y4ng

16

klguy

Ampang

1.3 Advance

Ocean Blue

Auto

Thanks 

ok done adding klguy and kc66 welcome. i assume auto unless stated ya.

- sound? Think i wanna ger D rubbers and DIY for doors.

Be careful in choosing the right D rubber coz the metal frame to stick the D rubbers to your back doors is pretty small . I lost both doors rubber within 2 days of usage. The rubber for the dashboard would be a bettr deal in my personal opinion. BTW TQ for the add 

Hi i'm new here

i would like to find out for the manual is it using clutch cable or hydraulic?

And notice got 1 member driving an manual if possible can take a photo of the engine compartment with the transmission portion of clutch slave pump and also the clutch master pump area.

tks in advance..

i think can just open the hood, find if there's a place to fill clutch oil if it is hydraulic based. axia/myvi is using clutch cable, cheaper cost, so most likely the same? correct me if i am wrong please, learning is important.