Thx for the clarification. Where can i purchase the socket converter ya? Or any car accessories shop able to do it?
I intend to buy the taillight as some seller do not provide installation. Thx

Seller quote 1.8k for city FL led. Grace blue tint version 3k++. So call mod or installation cost rm180. If simple as plug & play, i intend to install myself.
The front led headlamp are more complicated as u need the manual adjustment leveling suis as well.

Wahh!! China spec City got front parking sensor. Why we dun have here. Parking front in kinda hard wei!

Hi guys, anyone knows what's the cause of this noise out of the steering wheel? It would be good if can get some feedback here b4 I make a complaint to SC. No prob at all with my city fl for the first 2 weeks, now almost 1 mth old it makes many noises. Less than 1 mth old! Am so sad.

Rain water masuk front passenger floor issue still unresolved after 2 visits

No, what they did on 2nd complaint visit was to remove and re-seal the rubber.

No, what they did on 2nd complaint visit was to remove and re-seal the rubber.

Anyone knows where to buy paint for a little touchup? A small part of paint came off. Probably from a small stone while on a highway. Polishing yields no difference. I'm afraid if I don't cover it rust would enters from there. Mine is lunar silver.

Bro. Ur CFL do u have this hard metal bar like feeling at ur rear seat corners?

Tak faham

Ohh, so this is considered normal and because of the car structure.... Can teach how to remove the rear seats?

Total 369.65 for 10k service .

Ok ?

This morning, I opened my rear seats to investigate that hard/sharp metal feeling when sitting at the corner edges.
[attachmentid=8935054]

Apparently the seat mounting is just a raised piece of sheet metal, and the edges is what caused the discomfort.
[attachmentid=8935065]

I used some thick cloth rags and padded the edges.
[attachmentid=8935067]

Now, the hard feeling is still there, but the sharp edges have been dulled. 
All thanks to @baiseliange sensei for guiding me to source on removing rear seats.

My 1st mod as well.

not sure if need to go behind the rear mudflap or not, later i take pic let u see.

so far have not chance to try out yet, but I would like to know the result too.

total damage, rm 87.64 + rm 42 (air postage to malaysia) + rm30 = rm159.64. whereas, hingan quote me rm169.60 included the clips for 2pcs daun pisang.

The material looks kinda carpet-type material. I worry that mud, dirt, sand will stick onto the hairy surface.
But then if use hard plastic, then it defeats the sound proofing. 

I went for the first 1000km service today. It's FOC. Then, the receipt states the next coming 10,000km service is around RM 450.

How much you guys paid for your 10,000km service?

Mind sharing which service centre location did u go? Mine was at Rawang branch

Guys, anyone still experiencing the rattling sounds at driver's seat aircon area?