Hi Sifus,

I had an ERL for many years but could never set it up for use with Maxis BB with VoIP.

Somewhat rather tagging vlan 821 & 822 to pass through eth2 to maxis (or rather Thomson) router does not work.

Is this only supported on ERX (with switching feature)?

Any feedback is much appreciated.

This post has been edited by lazzy: Jun 18 2021, 10:49 AM

I’m not familiar with ERX as I own ERL which does not support on-board switching as I read but a chap at local Ubiquiti distributor suggest bridging the entire eth0 (connected to Huawei modem) to eth2 (maxis router - connected to phone), then the normal internet vlan to eth1 which is then connected to my standalone AP.

This works like a charm for me; hope this helps.