Hi..

Any idea if I have setup my ER-X using load balance and currently running on a Time Broadband connection. How do I set it up to use it with a TM Unifi? Can I add in the vlan directly to the eth port to accept a Unifi connection?

Hi..

I'm on 1.9.1 currently and already setup using Load Balance; not the one with vlan. But only one pppoe used currently. The 2nd pppoe is currently disconnected. I plan to use the 2nd pppoe with Unifi.

So, can I add the vlan to the eth port directly or need to setup from scratch again?

Hi..

Noted, thanks. Will try on that.

By the way, one more question, my setup is as below:-
eth0 - switch0.110, switch0.120, switch0.130
eth1 - pppoe1
eth2 - pppoe2
eth3 - switch0.110, switch0.120, switch0.130
eth4 - not configured anything

I tried configuring eth4 to assign IP by DHCP without any vlan. But, it doesn't seem to assign an address and I can't access internet.

I also tried being on a static address 10.20.100.100 as my ER-X gateway address is on .251, and I'm plugged in to port eth0 and yet no access to internet.
But, at same time, I have traffic coming in from eth3 via vlan 110, 120 & 130 without any problem accessing internet.

Am I missing out something here?

Sorry, newbie here..what's the command to get the config from CLI?