wow... 93C swt... even on my E8400 aircooled by thermalright IFX-14 OCed to 4.725GHz also cannot reach that temp..

Haha at 1.41v only . Soon the water also boil edi. I suspect is temp problem. When i off stress2004, temp drop to 70+. On it, back to 90+. But on my sonic tower, it 58C jump to 70. Not 90.

I don't think there are need for reservoir but might improve.

current progress.. setting up all the stuff starting leak test soon...





This post has been edited by IcEMoCHa: Jun 27 2008, 11:51 PM

oh?this the different between v1000 and v2000~

spacious~

damm large~

where to put the psu?on the rad?

just above the rad..

wooo stim stim

time for me to setup too

and today I hand the floor to another forumer i helped setup his WC rig, he will post it shortly

My setup is up and running,thanks to bryanyeo87.Benchie will be up tomorrow.Spec in sig.

done mine stock idle at 36C and load at 44C on a hot afternoon with AC off and rad fans at minimum.. not showing the bottom part 1st too messy ... and maybe later i use my camera to get a better photo... my camera phone sux at dark photos...



This post has been edited by IcEMoCHa: Jun 29 2008, 06:55 PM

Bro.. If you want to fit the res into the cd rom area, remove the panel that meant for floopy drive and i am very sure the res will fit nicely below ur cd rom or EX33. Anyway, hope you like the casing.. Its really one of the most spacious case I used before.

did anyone use cool sleeve spring for tubing..? i see the picture from internet...it is very cool when glow in the dark..

---

Added on June 30, 2008, 5:49 pmdid anyone use cool sleeve spring for tubing..? i see the picture from internet...it is very cool when glow in the dark..

This post has been edited by truzoids: Jun 30 2008, 05:49 PM

wah....cool watercooling....

yeah.. planning to get EX-33B soon.. my harddisk are burning hot..

Pic of my liquid cooled Enlight Lian Li Oem PC7A,cable management and installation done by bryanyeo87 And here is some crappy pic


Loop Spec:
Dtek Fuzion V2
Swiftech MCR220
Swiftech Micro Res
Generic 1/2" ID Tube
3xYate Loon Mid Speed(77cfm)
Swiftech Radbox
Nirox P2800

No clamps on the joints... later leak

As long as tube is joint to barb,it is already seal

u cant say tht unless u using 7/16ID tubings, if u use 1/2ID tubings on 1/2OD chrome steel barb, it is adviced to clamp the joint as the tubings will slip away from the barb if tight turns are bend. I've been experienced leaking when using those chrome barbs running sli setup without clamp, the tubings slip off itself a little from time to time untill small leak occur... so better use clamp unless u are on 7/16ID tubings...

all my joints are clamped.. better be safe than sorry haha..

My V2000B with watercooling... more pics coming up after i get my EX-33B and do some cable management...

hey bro, get a better pump in the future and also a gpu waterblock... LOL