Home Networking [Guide] Upgrade TP-Link 1043ND v2 to v3, Upgrade from v2 to v3 firmware
|
|
 Nov 2 2016, 01:08 AM
Return to original view | Post
#1
|
 
Junior Member
490 posts Joined: Jan 2006 From: Kuala Lumpur  
|
Thanks for the sharing.
I updated mine to V3 but found the Wifi Tx speed is fluctuating between 10-20Mbps while the LAN port speed is pretty constant at 30Mbps. Btw I am on Unifi 30Mb broadband. Did you observe this issue? |
|
|
Nov 4 2016, 08:52 PM
Return to original view | Post
#2
|
|
Junior Member
490 posts Joined: Jan 2006 From: Kuala Lumpur
|
Still the same after all set to 40MHz. I also tested the IPv6 support on both the LAN and Wifi connections.
|
|
|
Nov 8 2016, 08:37 PM
Return to original view | Post
#3
|
|
Junior Member
490 posts Joined: Jan 2006 From: Kuala Lumpur
|
QUOTE(jerryckk @ Nov 8 2016, 09:52 AM) Update: Still can't figure out how to get HyppTV to work. But the router is much more stable than v2 firmware. If you managed to get HyppTV to work, feel free to share here. In the meantime, if HyppTV is important for you, you may revert back to v2 by referring to the source article above until i figured out the solution. You may want to tweak the VDSL modem to serve as HyppTV output. This was what I did few months back before upgraded to V3. LAN1 connects to STB, LAN2 bridges to router WAN port.  Follow this guide http://stanleytiang.blogspot.my/2011/08/un...using-your.html This post has been edited by patricktoh: Nov 8 2016, 08:49 PM |
| Change to: |  0.0197sec
 0.35
 7 queries
 GZIP Disabled
Time is now: 12th December 2025 - 02:20 AM |
Quote