mine PC just used silent fan, don't want 'bising2'

I have 10 fans in my CPU...got pro and con as well..

positive side = look cool, emit heat more faster, better life span for CPU
negative side = wash so many fan, abit of noise

This post has been edited by eric84cool: Jul 12 2007, 03:44 PM

1 120mm case intake
1 120mm case exhaust
1 ??mm fan on my graphic card
1 120mm fan in my PSU

Not sure the size of the fan on my graphic card

1 for PSU
3 for Back side of casing
1 large for front side of casing

I basically have a delta high speed fan running as my exhaust, and a CM led fan as my intake... At the moment i am trying to silent my delta.. but i dont think its gonne work.. its too powerful

Also i have done a little mod to my intel stock cooler.. I have put a little fan on top of the stock fan with a windflow tunnel to concentrate cool air intake to the chip

1 cheap black 80mm fan at the back for exhaust
1 cheap black 80mm fan for front intake(blowing the hardisk)...
1 gigabyte 90mm cpu fan...
2x 80mm black fan inside icute power supply for additional exhaust fans...

My new server rig (temporarily using it as my main rig):

10x fans (including PSU):

1x CPU fan (Zalman CNPS9700)
1x 120mm intake fan - blows air into casing "through" 3x HDs (so acts as a HD cooler too)
1x 120mm exhaust fan directly behind CPU HSF
- all 3 fans are in a direct line.
2x 40mm fans in a HD cooler
3x 80mm side intake fan - blowing air onto HDs
1x PCI card slot exhaust fan - sucks air off the graphics card (fanless), and out the back
1x PSU fan

It's not noisy as the two 120mm fans are controlled manually (usually set to lowest), and the CPU HSF is automatically controlled.
The other fans are quite quiet except for the PCI slot exhaust fan which is a little bit noisier that the silent fans. But it's needed as it is at the top of the casing (mobo installed BTX style in Aerocool Baydream case), and I have a fanless 8600GT.

Purchased not installed into a MOD server casing

3x120mm for intake
2x120mm for exhaust
3x80mm for exhaust
1x80mm for intake
1x120mm for CPU

total 10 fans

i have
4 x 120mm fan
1 x Artic freezing 7 pro 90mm cpu fan
cpu temperature is ok..23-25 something but system 50++

Total 5 Fans...

1 x 80x25 Delta (intake)
1 x 7300GT Sonic Stock Fan
1 x Intel 775 Stock HSF
1 x 120x25 CM Real Power psu
1 x 120x25 Delta WB Fan Series (outtake)

Hard to calc the cfm laaa cause Asus Q-fan2 control their speed...
Normal CM Centurion 5 configuration.

2 X fans already inside enermax PSU
1 X fan already on Artic cooling 64
1 X Evercool VC-RF on VGA
1 X 70mmX70mm Delta controlled fan on HR-05 SLI Northbridge
2 X 80mmx80mm ayam fan as output
1 X 120mmX120mm CM fan as intake
1 X 80mmX80mm panaflo fan as intake to hdd

so didn notice i got 9 fans inside my pc until i counted here
CFM i tak tau kira larr..... maths noobi

But the MOST important priority i remain <23db sound

my pc dont have any fan in the casing when buying from lowyat plaza can i still using it without a problem

if u open the side panel of the casing should be no problem

my pc juz use 5 only~~~

2 x 8cm CPU Fan (Asus Pirates 70)
1 x 12cm
7 x 8cm
2 x 4cm HDD Cooler Fan

= 12 Fans

All Fans are Cooler Master except the PSU one.

2x front intake 80mm fan
2x side intake 80mm fan (blowing directly to the graphics card)
1x top exhaust 80mm fan
1x PSU exhaust 80mm fan
1x back exhaust 80mm fan
1x CPU Cooler Master Jet HSF

Reason for the fans: Overclocked CPU and graphics card

ZERO ...i use one big table fan blowing my entire casing ...

i think my computer don't have fan. except for the stock fan on my p4 processor and the fan on my 7600gs . so how many fan should i add so i can close my sidecase.

currently, i took of the sidecover, and place a table fan to blow it. if it is off, my pc will very noisy, if close the cover, more noise.

i think now only can put 1 fan which is for the back, to suck heat out and for the front, there's no air hole.

any idea on helping me?

Im using 5......

2 in front for sucking
1 on top for exhale
1 rear for exhale
and 1 side for sucking

Reason: Looks cool blue!!

added (following)

1 x Sanyo Denko 120 x 120 x 38 at the frontal, replacing crappy CoolerMaster 120mm case fan

1 x Delta 70 x 70 x 25 to HR-05 SLI, switched from fanless configuration

1 x Delta 80 x 80 x 25 direct blow to PWM IC area, instead of relying air flow coming from frontal panel fan...

... and i got this...

oklay, not too noise, but can hear those fans