Outline ·
[ Standard ] ·
Linear+
PROTON SAGA BLM, FL & FLX Thread V70, Final thread by TS
|
Ghostblind
|
 Aug 27 2019, 11:04 PM
|
|
QUOTE(Imagination *-* @ Aug 27 2019, 01:13 PM) SC confirmed that my fuse box need to be replaced but it is very expensive. Said my fan 30amp fuse loose contact with the fuse box under heavy vibration. And need it replace all. But is there any outside service shop that can fix my fuse box? In Klang valley. try PM this seller, recommended from cvt + cfe groups |
|
|
|
|
|
Ghostblind
|
Aug 28 2019, 08:35 PM
|
|
|
QUOTE(V12Kompressor @ Aug 28 2019, 09:04 AM) I was about to recommend adding+tap wire if the fusebox can;t be fixed. It's a cheaper alternative and can be safe if done properly (soldering, shrinkwrap). this method has been done by Apeng impian, relay put outside APeng Impian FLX |
|
|
|
|
|
Ghostblind
|
Sep 11 2019, 12:33 PM
|
|
|
» Click to show Spoiler - click again to hide... « QUOTE(homosapient @ Sep 11 2019, 10:08 AM) Hi Guys, Need help on my SAGA FLX. last month i had done major service, changed CVT oil. after that i problem started while driving the gear shows -- and gear went into free and error popped. but after off the engine and start again can drive normally. last week was driving from KL to Penang. once reached penang same thing happened but when try off engine and start reverse was working but when put into D shows -- and car not moving. after few hours cool down then can drive again. went to workshop the foremen said relay problem and changed 3 relay under the fuse box. when driving happened again gear went to -- and error showing. i took back to workshop and they serviced the gearbox and told me found metal chips. i took back the car and now when put to any gear its going forward and making some funny noise like metal sound and brake not working. Workshop guy told the gearbox hancur and need to change. not sure what to do now. error code got on fist incident was below. P004C - Powertrain P0705 - Powertrain - Transmission range sensor circuit malfunction (PRNDL Input) P1401 - Powertrain after change Relay below was the error P0036-Powertrain - HO2S Heater Control Circuit ( Bank 1 sensor 2) P1401 - Powertrain P1772-Powertrain     Where is ur location now ? |
|
|
|
|
|
Ghostblind
|
Sep 11 2019, 05:14 PM
|
|
|
QUOTE(homosapient @ Sep 11 2019, 03:16 PM) call this guy » Click to show Spoiler - click again to hide... « 01seven-303 four six four one or msg him thru facebook » Click to show Spoiler - click again to hide... « https://ms-my.facebook.com/is.is.12139862 he can help you to check and identify what the problem then u can decide which one much easier for u location klang Source : Fb group (cvt & cfe technical discussion) This post has been edited by Ghostblind: Sep 11 2019, 05:15 PM |
|
|
|
|
|
Ghostblind
|
Oct 26 2019, 09:31 PM
|
|
|
Guys, i want to ask
Why my car lights don't flash on the left side only when I lock/unlock the car?
if i turn on the signal left and right and hazard all working fine.
|
|
|
|
|
|
Ghostblind
|
Oct 27 2019, 05:12 PM
|
|
|
QUOTE(iskazulka @ Oct 26 2019, 10:05 PM) my guest is fuse problem check the fuse box under the steering, look out for 7.5A Alarm / Turn LH. check the fuse if putus or not. there is also fuse for 7.5A Alarm / Turn RH, 15A Hazard, 10A Turn Signal. QUOTE(goohtj @ Oct 26 2019, 10:06 PM) fuse blown. fuse box at driver side Thank you brothers.. now the alarm signals is working fine clean the fuse contacts with sand paper » Click to show Spoiler - click again to hide... « This post has been edited by Ghostblind: Oct 29 2019, 11:54 AM |
|
|
|
|
|
Ghostblind
|
Jan 30 2020, 01:49 PM
|
|
|
QUOTE(CasualMax @ Jan 20 2020, 09:41 PM) Hey all, previously my air intake mouth and hose (connecting to the air intake box) was missing after I sent my car for paint job. After 2 months, the boss finally managed to find one (bought a new one) and installed it. After that I notice there is a noise every time I step on the gas pedal (no noise if I step on it slowly and gradually). It sounds like air sucked in / leaked out. Here's the video, take note on the sound just before the engine revs up, it is the moment I press on the gas pedal. Also I noticed the hose connecting to the back of the box is actually dislocated.  I then tighten it back thinking it was the culprit of the sound. Right after fixing it back, I tried the same approach by pumping the gas pedal but the sound is still there. Is this normal? Cause I have been driving without the air intake mouth and hose for 2 months and I kind of forgot how it sound with one installed. The hose from air filter connect to throttle body no connect properly (the clips), u can do it manually |
|
|
|
|
|
Ghostblind
|
Sep 20 2021, 05:07 PM
|
|
|
Hi, need some advice..
Every time i try to lock/unlock the car, I can see the flash (signal) only right side, the left side no light at all?
But when I try using the switch signal the left signal is working
And when turn on the hazard light, it's working at all for both signals
The only problem is when lock/unlocks.
Is it my alarm got issue?
This post has been edited by Ghostblind: Sep 20 2021, 05:16 PM
|
|
|
|
|
|
Ghostblind
|
Oct 7 2021, 10:59 AM
|
|
|
QUOTE(iskazulka @ Sep 30 2021, 10:59 AM) can try change/swap use, fuse box under steering, 7.5A ALARM / TURN LH  p/s: last time same problem ka? go change ady. https://forum.lowyat.net/index.php?showtopi...post&p=94382389Thanks bro the feedback after diagnose for 1 day and check the fuse, bulbs seems like the alarm box got problem send to accessories car they said need to bypass instead of doing that i buy new original proton RM430 w/o labour charge, from facebook market RM205 |
|
|
|
|
Quote
0.1290sec
0.61
7 queries
GZIP Disabled