Outline ·
[ Standard ] ·
Linear+
PROTON SAGA BLM, FL & FLX Thread V70, Final thread by TS
|
AhJetz
|
 Jan 14 2017, 11:10 PM
|
Getting Started
|
bro, having some issues just now. heard some rumbling sound on my saga FL then went to stop nearby to check the engine but the engine did not shake violenty just the sound je then see temperature higher thn normal 1 bar so stop engine and let it cool down for about 30mins
then came back to open bonet to check the water. pour in some water already full means water no less and checked the dipstick too no leakage no problem. then i try start engine to see how it goes. after minutes i saw there is a slight smoke came out so i quickly turn off the engine.
Anyone had problem like this before?
|
|
|
|
|
|
AhJetz
|
Jan 15 2017, 09:28 AM
|
Getting Started
|
QUOTE(goohtj @ Jan 15 2017, 09:08 AM) forget to check as that time is already 10pm so i sit car friend to went back home. later will be going to find a nearby workshop to check the problem. any reliable and working today on sunday near sunway university? |
|
|
|
|
|
AhJetz
|
Jan 15 2017, 08:01 PM
|
Getting Started
|
QUOTE(goohtj @ Jan 15 2017, 10:29 AM) so many workshops there. to check fan, very simple. start car, on aircon, fan must on automatically . if not replace fan motor.. yeah it is the fan. the bracket melted already until it stuck on the fan |
|
|
|
|
|
AhJetz
|
Jan 17 2017, 02:05 PM
|
Getting Started
|
QUOTE(sanosizo @ Jan 17 2017, 01:41 PM) I had similar issue, temp suddenly increase and aircond not cold. turns out the radiator fan not working when aircond switch on. went to workshop check/replace fuse and relay all seems fine so they suspect the fuse box spoilt. I went back home did a bit checking, when I press the fuse box suddenly the fan works. remove my hand then it stopped working again. so I assume the fuse box connector somewhere got loose connection or bad contact point. went to store room find some garden wires then I hooked the fuse box. so far it has been 2 months like that, no time yet to remove the fuse box and check/clean the contact point/connector... yup after changing my fan it still not spinning so we checked the fuse box and yes the clause was from it. but it was too late cause my fans motor already burnt until melted d |
|
|
|
|
Quote
0.0215sec
0.46
7 queries
GZIP Disabled