Crossover DIY, how to
|
|
 Jan 21 2007, 12:19 AM, updated 19y ago
Show posts by this member only | Post
#1
|
 
Senior Member
1,129 posts Joined: Jan 2003 From: Kuching, Sarawak   
|
im noob in audio system...now wanna DIY myself..
here my current setup HU -> preamp -> woofer i got 2 way passive crossover, but dunno how to DIY, on the crossover it got IN, TW, and WO. as far as i know..in is signal from my HU, TW maybe tweeter...andwhat for is WO? i wanna do like this HU ->Preamp -> 4 Channel amp -> tweeter,front/rear speker where to put crossover? |
|
|
|
|
|
Jan 21 2007, 12:29 AM
Show posts by this member only | Post
#2
|
Junior Member
212 posts Joined: May 2006 
|
wo = woofer
hu -> preamp -> 4 channel amp -> 2way xover -> tweet, woofer (front) since ur 4 channel amp now will have 2 more channel free, u can use them direct to drive a rear pair which is normally a full range. get something like 6x9 is good for rear, but it is better to not have rear at all |
|
|
Jan 21 2007, 08:30 AM
Show posts by this member only | Post
#3
|
Senior Member
7,842 posts Joined: Sep 2004 From: Pandan Jaya,KL 
|
IN = INPUT
TW = TWEETER WO = Mid bass |
|
|
Jan 21 2007, 10:06 PM
Show posts by this member only | Post
#4
|
|
Senior Member
1,129 posts Joined: Jan 2003 From: Kuching, Sarawak
|
 thanks very much guys...just finish all audio setup today.. |
|
|
Jan 23 2007, 10:43 AM
Show posts by this member only | Post
#5
|
Senior Member
2,702 posts Joined: Dec 2004 From: P8X-86A
|
Hey guy, how was the speaker?
|
| Change to: |  0.0168sec
 0.44
 5 queries
 GZIP Disabled
Time is now: 1st December 2025 - 11:29 PM |
Quote