Can't use standalone gyro lar...

I was thinking using strap velcro, but main couse is my double sided that comes with the gyro slowing come loose.
So after replacing with 3M it's as good as new... i think i can save RM400 for GY401 then..
I changes back using Align 35A ESC from the HobbyWing 40A ESC... the Align 1 still more stable with 6v BEC, better for all the servos.

This post has been edited by cliffang83: Jun 19 2009, 11:01 AM

who said cannot ??
dump the 4n1 ... use a futaba/spektrum/etc rx .. kowtim ... hahahahahahaa

---

Added on June 19, 2009, 11:15 amgood ... saved rm400 liau can go get the miniature heli .. hehehehe

u using the align esc with built BEC 35a ah ??? what servos u using ??

This post has been edited by QiW: Jun 19 2009, 11:15 AM

i use the Hextronik MG-14 from uniquexme, wanted to use those on the belt cp but decided just put it back into the box.
Rudder is the Hyperion DS12-GCP supporting 6v @ 0.6sec.

hows the performance of the mg14 ?? good ??
i might have to buy some to keep as replacement for the align stock ones .. hahahha

So far no problem stable during flight. Reliability is yet to know.
Your align servo is a better 1.. why down grade??
I was thinking getting those for upgrade too.

the ds410m from align alot of ppl complain in the internet ... intermittent failure sometimes or so it seems la
those intermittent failures are enuff to cause u to drop to ground liau lorr .. hahahaha

but apparently it only applies to ppl using 450 pro so far .. some say it is becoz of the frame of the 450 pro so tight that alot/most ppl forced the servos in and over tighten them worngly ... that causes the binding within the servo itself due to stress on the servo casing ... and thats the thing that causes servo failure for the ds410m in the 450 pro

now u know how much i read and why i am taking my own sweet time to build the 450 pro ??? hahahahahahaa

You really read a lot.... a caution person....
The new Hitec 5065MG is better isn't it?

its about the same standard according to internet .. only thing is the hitec performance and reliability is proven .. for the align performance but reliability issue ...
so far ppl put it in the pro and no complaints yet
maybe the casing of the hitec can take stress better

Go for hitec then... since you can affort...
For me, i enjoy slowly upgrade... so more chances to take this out, put that in... fine tune... more building time...
By doing that acctually i found out many unforseen problems with my 450, so rebuild it again..
If not, everytime will just like: fly, then back to the rack; fly again, put back to the rack.
No maintenance at all.

This post has been edited by cliffang83: Jun 19 2009, 12:17 PM

i will just try with the stock align ones 1st laa .. i will to fit in the servos as best as i can without compressing or stressing the casings ... see if they hold up in reliability or not ... if they do then its the installation thing liau

i cannot afford la weiii ... now still sourcing for the wires ... no flight time is damm kow depressing
just now whack the sim until heli oso cannot stand me liau ... hahahaaha
my orientations in ff bf inverted ff are getting very good in the sim .. real life i suppose there is still panic and fear of crashing that affects the pilot laaa

i just cannot catch the timing to do piro flips laa .. looks nice but the rudder damm kow slow in the sim unlike in real life
i have bumped up my physics in sim to 120% since long ago ... maybe i need to bump it up another 10% just to make sure old man reflexes like mine still works properly .. hehehehe

u are re-builder ma ... so enjoy rebuilding lorr .. i enjoy FLYING !! hahahahahaa

This post has been edited by QiW: Jun 19 2009, 12:53 PM

No la... not goin to install so many thing for the HBFP2...
Now searching for DD tail motor... No need gyro... Can use back 4in1...
Gao Tim...

Careful is good, once it up flying, there's no room for mechanical error.

I have not played sim for weeks liao... hehehe... busy with my console... Maybe to night will play since tomorrow not working.
Every night, i'll take the 450 out to fly for 2 packs then back to the console. My wife has started to complaint.
Still watch around if anyone selling cheap combo offer for Trex 450/compatible...

This post has been edited by cliffang83: Jun 19 2009, 01:41 PM

then she will say why not every nite go for 2 ROUNDS then go sleep ?? huahahahahaaa

my console collecting dust .. PC games are better for me ...

---

Added on June 19, 2009, 1:44 pmBRUSHED dd for the tail or BL ??
if brushed then ez to find lorr .. even brushless oso should not be hard to find for motor that size

u never ask fx20v if he got any meh ??
or just convert to belt drive la ... no more headaches .. hehehe

the amount of $$$ u spend on the hbfp cost more than copterX kit liau or not ?? hehehe

This post has been edited by QiW: Jun 19 2009, 01:44 PM

2 rounds??!? Later hari-hari-mau.
Like that no time for my heli lo~

I prefer console cause my PC outdated de... Console cheaper to play with.

This post has been edited by cliffang83: Jun 19 2009, 01:46 PM

not only no time for heli .. no time for anything liau coz u will be dead exhausted during the day and bz servicing during the nite
later u scared until dont dare to go home then u know .. hahahahaahaha

dont hover hover in room la since u already know how to fly ... take it out and let it loose !!!

Hover in room can train till no error for mistake... Will try to keep it steady without much movement...
Feel like going for roller coaster ride... hahaha... heart beat also faster..
I took it out to fly ar... then just simply control as long as it stay within the 6ft x 6ft area...

Brushed DD tail here don't have lar for HBFP2...
No one got it at the moment...

The amount of $$$ still not enuf to spend on a CopterX kit...
Even enough also won't be buying CopterX...
I can't afford to spend so much $$ like u mar to repair it...
CopterX crash is much more expansive then HBFP2...

Sometimes read too much in the internet also no good...
Trial and error needed also...
Prevention is good but who can assure u that no mechanical failure will occur even if u upgrade to best part?
Lost all the fun liao lor like that...

BTHO got 1 fella fying the Pro kit using all Ori staff...
U see the way he fly it also
But he is damn sifu liao la...

hmmm ... go 2 weeks oso not yet see the 450 pro in action .. maybe that sifoo crashed liau ?? hehehehe
everybody crashes one ma ... even bird camera and lookas riva and alen chabor ... hahahahahaaa

FINALLY GOT MY WIRE !!!!
damm kow hard to look for it but at least i know where to look for rewinding wires la when i need it next time .. but definitely not for the 2.9g BL tail coz i got enuff to last me 10 life time ... hehehehe
that place got all sorts of sizes .. but not all the time they sell coz they are not in the selling wire bizness one but of coz i managed to persuade them laa

REWIND MOTOR TIME !!!

Normally on weekend u'll find him fly nitro on the other side of BTHO...
Weekday he fly 450 Pro...