nice! keep trying bro
sure can get higher speed 

please do post up some screenies, and maybe we can help u push even further

i believe 800x7 = 5.6Ghz!!!!!!  and tat means ur ram is running 1600mhz!!!    and 2.45 is ur vdimm or vcore ? 

use orthos it is specialized for dual core processor 

dl it here :

http://sp2004.fre3.com/beta/orthos_exe_20060420.cab

use orthos it is specialized for dual core processor 

dl it here :

http://sp2004.fre3.com/beta/orthos_exe_20060420.cab

Do u really need 1.40 v to run at 3ghz?

Whatever it is, 1.4v is still within 10% of the default vcore. 1.55v would be overvolting your processor.

Note: I do not take any responsibility for any failure, explosion whatsoever coming from direct, indirect, perpendicular use of the rated vcore!

anyway, try playing around with your vcore, you 'should' be able to hit 3.0ghz with less than stock vcore. Mine is 3.0ghz @ 1.25v

Here's a good guide for overclocking e6300 (or any other conroe for that matter)
3.0 GHZ easy

devilman, u need to oc step by step. increase ur fsb, then run orthos for 5-10mins, if no prob, increase fsb again, i say 5 fsb each, then run orthos again.. repeat until iorthos fail and then u need to increase ur vcore.

Ya, my ram memory multiplier is set at 2.00 for 1:1 ration. Is that th one? lol

hehehe u got so much time to do..then ok lorr...others ppl dunt have time like u..so minimum requirement 6 hours plus should be ok..
most ppl do 3.0Ghz-3.2Ghz within thier default vcore (1.325v) or just a little increasement (between 1.35v-1.375v) becoz some mobo got the vdrop while priming their proc...

if u go above 3.2Ghz...is likely u have to increase ur vcore above the default...but there is some gem c2d that can run under voltage at high speed...but hard to find...n if u have it..u r lucky...

My CPU should be able to achive a higher FSB, but for that i would have to raise my RAM FSB right? My ram is ddr800 so do i just raise the fsb or the latency as well? Im not  quite sure about this part.