Welcome Guest ( Log In | Register )

Outline · [ Standard ] · Linear+

 [wta] format it cant detect hdd

views
     
TSsilrave
post May 16 2016, 09:52 PM, updated 8y ago

Look at all my stars!!
*******
Senior Member
5,836 posts

Joined: Jun 2006


guys
when i install new os
put bootable pendrive and F12 select it
go in to os , after select installation
it say cant detect my hdd
i have try use cmd disk part and clean it
still the same

some say setting on mobo to set ahci
but this is asus new mobo
i cant see any setting to change ahci

any solution
Mr.7
post May 17 2016, 01:16 AM

Regular
******
Senior Member
1,242 posts

Joined: Sep 2013
From: Quantum Universe
open cmd(command prompt) through windows installation,u can find it on repair my computer
type diskpart
then u type select disk <x> where the <x> is the drive u want to use
then type clean and done
check the disk partition in custom installation
and here u go,windows installation
TSsilrave
post May 17 2016, 01:43 AM

Look at all my stars!!
*******
Senior Member
5,836 posts

Joined: Jun 2006


QUOTE(Mr.7 @ May 17 2016, 01:16 AM)
open cmd(command prompt) through windows installation,u can find it on repair my computer
type diskpart
then u type select disk <x> where the <x> is the drive u want to use
then type clean and done
check the disk partition in custom installation
and here u go,windows installation
*
hmm
i got do
clean all
active
format fs= ntfs

maybe i try ur solution and see
Netto Hikari
post Jun 17 2016, 08:40 PM

Solution Architect?
*******
Senior Member
2,394 posts

Joined: Jan 2003
From: Selangor


installing windows xp or 7 32bit? they dont have native ahci drivers, u need to load sata ahci drivers prior to installation.

http://windows.microsoft.com/is-is/windows...drive-not-found

if u dont wan the hassle, go to bios and switch the sata mode to native ide.
dcheah
post Sep 14 2016, 06:00 PM

OldSkool
******
Senior Member
1,233 posts

Joined: Jan 2005
From: Kajang


QUOTE(silrave @ May 16 2016, 09:52 PM)
guys
when i install new os
put bootable pendrive  and F12 select it
go in to os , after select installation
it say cant detect my hdd
i have try use cmd disk part and clean it
still the same

some say setting on mobo to set ahci
but this is asus new mobo
i cant see any setting to change ahci

any solution
*
You will need to download the storage controller drivers from your mainboard manufacturer website, during the install wizard where you select which drive to be install, you can load the drivers there then refresh the screen.

You should be able to see your HDD by then, next is to create partitions as you see fits & install like normal.

 

Change to:
| Lo-Fi Version
0.0124sec    0.41    5 queries    GZIP Disabled
Time is now: 29th March 2024 - 01:05 PM