Glass Roof , Polycarbonate Roof , Alucobond Roof, Extension roofing for car porch
|
|
 Apr 19 2016, 08:59 AM
Return to original view | Post
#1
|
 
Senior Member
8,739 posts Joined: Aug 2009 
|
QUOTE(yeohsheng @ Apr 19 2016, 07:36 AM) I'm trying to turn my porch roof to become balcony that access from my master bedroom. It is a huge area...i think I'm looking at 22ft wide x 20ft long. It seems it will make my balcony very very dark.... And expensive too? What is your suggestion? Depend on what your budget is and your design you want |
|
|
|
|
|
Jun 23 2016, 08:17 AM
Return to original view | Post
#2
|
|
Senior Member
8,739 posts Joined: Aug 2009
|
QUOTE(Kelv @ Jun 22 2016, 07:56 PM) [attachmentid=6910135] I believe is aluminium with foam inside. I had something similar install for my car porch ceiling. Is good material but need someone skilful to do it. The last I got it done by some inexperienced guy, the end result is bad.May I know what material is it? How much? The picture shows top, side and bottom. |
|
|
Jun 23 2016, 10:39 AM
Return to original view | Post
#3
|
|
Senior Member
8,739 posts Joined: Aug 2009
|
QUOTE(Kelv @ Jun 23 2016, 10:03 AM) How much and what's the consequences of the bad result? I am considering this for my backyard extension roof. Cost 5k. For area of 500sq feet. The bad result in installing, it makes the corner joint very uneven. The down light hole was cut badly and cannot cover properly after install downlight. The joint also look ugly because of bad workmanship |
|
|
Jun 23 2016, 11:19 AM
Return to original view | Post
#4
|
|
Senior Member
8,739 posts Joined: Aug 2009
|
QUOTE(Kelv @ Jun 23 2016, 10:46 AM) That's around RM10/sqft, that's cheaper than polycarbonate? I think I got discount that is why is cheaper. Anyway that company who do for me had disappeared |
|
|
Jul 2 2016, 02:25 PM
Return to original view | Post
#5
|
|
Senior Member
8,739 posts Joined: Aug 2009
|
QUOTE(Kelv @ Jul 2 2016, 01:57 PM) Asked few contractors, all haven't use this material before. They said normally just one layer. Then got a contractor recommend aluminium composite panel instead. The foam inside is for keep out the heat. I will say is good material but my case is just got the wrong company |
|
|
Jan 13 2017, 03:24 PM
Return to original view | Post
#6
|
|
Senior Member
8,739 posts Joined: Aug 2009
|
QUOTE(y4ng @ Jan 13 2017, 01:44 PM) hello sorry to bump an old thread, i just wanna ask, is the noise level low enough? i plan to use this for my single storey house cos of budget. I can't tell because the part I did is for car porch which is concrete roof. The aluminium is just to cover the ceiling from below. |
|
|
Jan 13 2017, 04:47 PM
Return to original view | Post
#7
|
|
Senior Member
8,739 posts Joined: Aug 2009
|
QUOTE(y4ng @ Jan 13 2017, 03:31 PM) ah ok, i will try to ask Mr. Tan and see, now facing a big challenge to replace RC type roofs. Thanks a lot! Anyway, the one I got the company is really lousy. Just be careful when you look out for one |
|
|
Jan 13 2017, 04:58 PM
Return to original view | Post
#8
|
|
Senior Member
8,739 posts Joined: Aug 2009
|
Mr Tan is ok but I am saying the one I got for the aluminium was bad
|
| Change to: |  0.0214sec
 0.14
 7 queries
 GZIP Disabled
Time is now: 6th December 2025 - 06:29 AM |
Quote