What do you guys think between these two casings?

Share you opinion on it

I am looking to buy master case 5 pro to upgrade my 690 III .

Thanks for your suggestions, but i not really into Phanteks casings. I like CM casings more.

i put sickleflow X on 3 pin to molex adapter and it spin hella fast - noisy.

using 690 III currently and only standard 120mm CM case fan. the very cheap one.

Looking for 140mm BC 140mm from CM also cannot find.

it has lol... 14cm fan. you go cooler master site and see

Even mastercase 5 pro feature 3 14cm fans. 12 cm fans is abit small i think.

lol, i just want to try use 14cm fans/


is 14cm better at moving move air than 12cm?

Here's the configuration in my casing currently

Rear is Jetflo

Top is 2 x CM 12cm standard fan

HDD cage with 1x CM 12cm stand fan , work as pull air from HDDs

Front is the Megaflow

There's a empty one at the bottom of the case, i haven't install fan yet

Have 2x Sickle Flow at bay. Put aside due to noise when it's running on molex power and not controlled by motheboard or Fan Controller.

Should i get a Fan Controller?

My Jetflo is quiet

it's on adapter on it's on the motherboard fan pin.

Yea, i guess i don't want Fan Controllers anymore.

Maybe i will try Fan Splitter , like one 4 pin to many 3 pin ... is this control all fans at the same speed?

Yes, its is quiet. If i don't use the adapter on the Jetflo, it will be very loud.

the adapter exist for the purpose. why no point?

I am plannning on getting a spillter and use it to connect some sickle flow and connect them to the Chassis fan port on the motherboard ( i still have one left ).

And why this thread becomes a case fan thread when i am asking your opinions on which case you guys think it's best.

Using 690 III currently. Just having a though of changing to a newer casing only.. if you guys says go for it/ based on yours reviews and thoughts.

LOL

Yes it's a good case, however,

1. Just cleaning the front filter very problematic as i need to remove two side panel, and then only can remove the front panel.

2. The Bottom filter have a large gap in between the case and the filter. I am thinking the air have problem passing through efficiently and causing my psu fan to act up. ( a possibility )

It's okay now, the psu. Master case 5 pro however meets some of my requirements

- removeable front filter without removing entire front panel.
- bottom filter seems larger and wider
- the legs seems taller = more air for the psu to breath?

on the plus side, there's psu compartment,
on the down side, hdd is now revealed, not much cable tie point like 690 III has,

still thinking whether should buy one though....

I clean my filters twice a week. A few days after i clean the front filter, dust already built up. psu's filter too.

I use paint brush, it cleans them nicely. I only bring the psu ( full modular ) and have stick to stop the fan and then blow at motorbike shop.

Too risky lol, i afraid later got scratches as the shop always packed all time.

Those air-brush one should be sufficient enough right?

Blowing while brushing should do the job well.

Well, you can say that. I think i will wait and see any new case Cooler Master has to offer.