hahaha, not that case. It was not until i drop by osren last week that Henry shine the lights onto the car that i notice it. I expected some, but that many. drives me crazy. Yup, 15 litres is my usual. Will look into the drying part. My current practice is to wet the microfiber tower, mist ONR as drying aid (QD mix) , spread and pull. second wipe down with dry microfiber tower to make sure it's 100% dry. Any dirt or spot will spray more onr and wipe.
Learn to dry with water......then there's "almost" no need to wipe.
Looking for one that does not attract too much dust, water spots, road grime and road film...makes washing easier...beading and visuals not that important. Tq.
any1 knows whats the estimate cost to repaint back the bonnet, roof, bumper n fender? 2K Super Black 2 color. if possible puchong area pls..
You are claiming from the company right? Get a few proper quotes from the painters lah...at least black easier to match. ...negotiate privately to paint the whole car see how much...
I would go make a police report also for protection in case they don't pay to go for small claims court...
This post has been edited by dwRK: Mar 19 2016, 12:22 PM
Strangest LSP I've ever used...looks and smells like hand cream...as it bonds with the paint...the emulsion breaks down and water is released...eventually soaking the pad...need to periodically squeeze the pad dry!!!
When fresh... beads like wax...sheets like most polymer...adds some gloss...very grippy not slick or smooth at all...will see how long it will last and how easy it is to clean...so far is looking good...could be a sleeper...alternative to PNS?
This post has been edited by dwRK: Mar 21 2016, 04:34 PM
Further thoughts on the armorall extreme shield wax...
It's quite expensive...working out to RM 14.5 per car ...in contrast ag's hd wax say at RM 400 per tub is only about RM 8 per car... I don't know if it is going to last twice as long to make it equitable...
No I didn't, both ICE and BSD applied directly to the bare paint surface. I have another car coated with the Sonax Polymer Netshield for the past 2 months. I will share the water beading picture next week for the forum to judge its durability.
Well...these 3 are modern synthetics so should last quite a bit...they have great reputation for beading/durability anyway...
I tested an old wax rain hop vs extreme shield...durability and beading aside the wax attracted more dirt and is less easy to clean...so that was defining
The extreme shield is also tacky/grippy like BSD/PNS...I'm guessing it has comparable formulation and it's my plan to extend it with BSD
if you wish I can give you some extreme shield to test with PNS...
guys, can plz recommend me where to clean my iriz cabin and boot? bad luck strikes me, my boots filled with rotten smell. i tried to wash the boot myself but still the smell remains...
Did you spill something to cause the smell?
If not, check for dead cicak... If smell persist for few days...& like coming from the vent/air-con...most likely dead at the air-con coil.
previously using soft 99 fusso coat (i think is AIO)...now wan to try use pinnacle sealant + wax top up..read frm internet i nid to clay and use paint cleaner in order to put sealant...wil use glaze before sealant too...
Mar 8 2016, 07:04 PM
...then there's "almost" no need to wipe.
Quote
Tq.
but always headache to maintain 
0.5451sec
0.73
7 queries
GZIP Disabled