assign rca input. direct mode. fix a volume level match with denon
not a good idea sure kena increase latency (delay).
front ch always prefer the shortest path

assign rca input. direct mode. fix a volume level match with denon
not a good idea sure kena increase latency (delay).
front ch always prefer the shortest path

1) fix = static not moving. once decide u leave it forever

2) before audysey. u put denon front ch level to zero db. never change it.
not master vol yaaa

3) later we use denon built in test tone to ear match front LR (using pioneer see step 4 below) vs center ch (dont change original value).
becos they r nearest positon

4) pioneer adjust master volume only (pls erase current mcacc memory bank). save as power on db.

5) run a audsey calibrate. he make all channel level equal.
check channel level result. as long any of them not touch limit 12db =pass

ideally front LR number near zero. u may repeat step 4,5 until satisfy

step 3. use the current result (you did yesterday).
force front LR to zero. so that denon wont add boost or reduce loudness.

roughly ear match LR to center ch, make it acceptable range

do above all before step 5 final calibrate

audyssey run one position ah.
dont be lazy. do at least three position

middle seat, left seat (same distance but in front of left ch) & right seat (same distance but in front of right ch)

so it wont boost treble until max.
otherwise we increase toe-in angle

pioneer zero db is good enuf. going higher may explode hahaha

^explode when anything wrong happen/ mistake.
more equipments = more $$$$$$ careful needed

overall u did correct (i guess ya. not live tutor session)

https://www.samsung.com/us/support/answer/ANS00080318/
yea bro.. i m using 1.. but cant feel shit abt atmos.. more like equalizer change when i enabled the atmos on my phone

i put it over my head then i lost my front stage