How to drill a hole in the wall super accurate ?
|
|
 Feb 2 2016, 11:58 PM
Return to original view | Post
#1
|
 
Junior Member
21 posts Joined: Sep 2011 From: give donasi ............................ 
|
tumpang ask , why i drill for wall plug screw, steel type , cannot hentam in , although the
drill already masuk the length i want , susah hammer in wall plug ,i keep drill many hole and it just eerytime hammer in , the nut or head spoil , either it is too hard to hammer in , or too loose , -500x500.png) This post has been edited by DSEcomp: Feb 2 2016, 11:58 PM |
|
|
Feb 3 2016, 12:22 AM
Return to original view | Post
#2
|
|
Junior Member
21 posts Joined: Sep 2011 From: give donasi ............................
|
QUOTE(narf03 @ Feb 3 2016, 12:03 AM) you need the hole to be same size or slightly bigger than the "pipe" on the plug, and when hammer it in, loosen the nut, the hole need to be deep enough for the entire "pipe" plus the head of the screw to go in. i am installing these too, i purchased item that come with low quality anchor wall plug, and im changing them to something bigger, more reliable, its not that difficult to put them in. oh btw dont make the hole too big, or the wall plug will be useless. i think u buy pull up bar , i also , my father use spanar hole as washer to beat the circle foreskin , slowly by slowly. only can go in , i make alot of holes , but failed , i as a beginner of drilling , my father very tarik harga , and like sindir people , finally have to ask him to do , i would have call the welder do if not my house full of pets , 4 hole each side , both side 8 total , my father managed 7 of 8 holes , while i manage none , ask the welder do is more worth , i dont know wasted how many wall plug........................... This post has been edited by DSEcomp: Feb 3 2016, 12:24 AM |
| Bump Topic Add ReplyOptions New Topic |
| Change to: |  0.0172sec
 0.70
 6 queries
 GZIP Disabled
Time is now: 19th December 2025 - 06:12 PM |
Quote