Cause if using a 2 channel with high current also can pump 12" woofer until like jumping very high.
Then after using monoblock what different is it more powerful then woofer will break or not?or the power is same but will produce more beautiful bass???

and
wan to ask the electric crossover have 3 way only
if i put one for subwoofer one for component and another one for my 6x9 5 way can??
Cause 6x9 also going to 5 way already wan to ask can use or not?

throw the 6x9 away. 6x9 should only be used if u dont have a woofer in the car to make up for the lack of bass. but if u insist on using the 6x9 with the woofer... get ready for some seriously shitty bass/ sounds.

as for the monoblock. it helps to deliver cleaner power to the woofer. more stabil. and the monoblock should run cooler than a 2channel amp.

the x-over is usually used to split signals from HU to amps. 1 way for front..1 way for rear and 1 way for sub.

monoblocks don use up a lot of power from ur batt but can produce high power.. the bass will b more powerful and u can hear that ur woofer is reacts faster than b4 (if ur current setup is not the max for the woofer)

*class D's monoblocks are not as accurate as class AB's monoblocks..

i am using two bazooka 12" with 500 watt peak and 250 watt rms
so which monoblock can recommend for me?

and now my front using a pair of component 6.5",a pair of woofer and the 6x9 in back so if throw 6x9 what should replace in back?

Back speaker just disconnect loh...

wrong la... power drawing determine by its class and efficiency la
not monoblock, 2channel or 4channel

normally class D monoblock SNR higher than class A/AB monoblock

Since now u using a pair of 12' sub woofer, then you can throw away ur 6x9 speaker. Cause 6x9 speaker sound will spoile ur whole nice sound. If you throw away your 6x9, now what you need is more treble sound. Since u using a pair of 12' i believe the bass for ur car already enough.

I will suggest to add 1 more component set or 2 way coxial speaker to give more treble.

yarhh.. sorry.. not monoblock.. it's the class

Ya,now treble needed bass enough.erm and monoblock wanted,dont know this thing worth or not ??
PYLE is it branded ar??

http://www.zerotohundred.com/newforums/sho...=pyle+monoblock

yes it is.. but i heard that there r imitation stuff.. so becareful..

juz for ur info, alpine's monoblock ain't bad too..

Wahaha.. A real Alpine supporter...

erm fren here my car now front component Eton not very powerful in treble then back have 2 12" woofer and 6x9 5 way,after take out the 6x9 5 way what should i replace ,now only need treble?

Help what is powerful in treble ,bass enough.

you actually got an eton comp set for front ar?
btw i dun understand what you trying to say
can clarify

What amp you are using now?
Does your amp have enough power to power your Eton Component?
You tune your amp urself?

erm i think is amplifier problem cause my car last time using a sound stream amplifier very old one come from my father mercedes,after that the amplifier broke so i replace with a used also 400 watts class A,so the sound is very low,T.T"

now know already my eton component can produce treble so need to change a amplifier for it.

Thanks Bro

Which amp you using?

which set of etons you using?

dont know come with my father's car also in the component tweeter and the box writing eton

IMHO, monoblock class D amp no control n not clean, cannot said that monoblock is much more powerful than stereo amp. It determine by rms.

elec xover, not split signal from hu to amp, it is to cut frequency points that u intended to send from xover to amps. Ur hu sending signal (depends on manufacturer's specs) eg, full range out. U need to send some correct frequencies to ur tweets, mids n woofer.

well said