Dec 19 2006, 11:23 PM
QUOTE(Dothan @ Dec 19 2006, 10:24 PM)
Hi All,
A short update on my xbox, i opened it again to re-coat the artic silver. Below is my steps:
1. Found out the previous coating was too thick, this is no good.
2. Cleaned up the mess
3. Polished the heatsink with sandpaper
4. Re-apply the artic silver again (this time very little and smooth the surface with unused credit card)
5. Running dead rising to raise the heat on GPU
6. When it is hot, press the ram chip to ensure firm contact.
Now praying hard it can minimise the glitches
haha very good idea!! A short update on my xbox, i opened it again to re-coat the artic silver. Below is my steps:
1. Found out the previous coating was too thick, this is no good.
2. Cleaned up the mess
3. Polished the heatsink with sandpaper
4. Re-apply the artic silver again (this time very little and smooth the surface with unused credit card)
5. Running dead rising to raise the heat on GPU
6. When it is hot, press the ram chip to ensure firm contact.
Now praying hard it can minimise the glitches
DIY , will the artic silver stick to the heatsink or it'll just melt off because of the constant heat?
Quote
0.0155sec
0.31
6 queries
GZIP Disabled