Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed

Outline · [ Standard ] · Linear+

> LYN OFFICIAL VAPING THREAD VThirtyOne, #VapeResolutions2015 complete?

views
     
gn9746203
post Dec 13 2015, 09:41 PM

Casual
***
Junior Member
302 posts

Joined: May 2009
Hi guys just bought a velocity RDA Clone from vape empire ... anyone know how da fuk do i unscrew and get to the build deck ?
gn9746203
post Dec 13 2015, 09:56 PM

Casual
***
Junior Member
302 posts

Joined: May 2009
QUOTE(andyng38 @ Dec 13 2015, 09:46 PM)
Screw the velocity to a mod or heat sink, and pull on the topcap...HARD! The 2 o-rings at the base section are very grippy.
*
pull it out ? Or try to unscrew it ? I took out the air flow cap then I am stuck
gn9746203
post Dec 13 2015, 11:08 PM

Casual
***
Junior Member
302 posts

Joined: May 2009
QUOTE(andyng38 @ Dec 13 2015, 10:07 PM)
Screw back everything, then PULL the topcap. HARD. NOT KIDDING.
*
thx alot .... finally get it open damn ....
« Next Oldest · The Museum Of Kopitiam · Next Newest »
 

Bump Topic Topic ClosedOptions New Topic
 

Change to:
| Lo-Fi Version
 0.0193sec    0.24    7 queries    GZIP Disabled
Time is now: 30th November 2025 - 06:44 PM
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Removal Request
Powered by Invision Power Board © 2025  IPS, Inc.