Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed

Outline · [ Standard ] · Linear+

> LYN OFFICIAL VAPING THREAD VThirtyOne, #VapeResolutions2015 complete?

views
     
SUSSpecial Agent
post Dec 14 2015, 04:34 PM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(gnomemaster @ Dec 14 2015, 03:30 PM)
Regulates = mods with chipset to help u regulate the wattage and voltage.

Unregulated = mech mods, with no chipset. It always fires at maximum output depending on ur battery level.

I remember jimbo or someone shared the safety chart for battery amp discharge at any given resistance. Basically, for safety, don go below 0.1ohm lol.

For regulated mods, feel free to play around the watts, u wont get fireball that easily, jz harsh dry hit that hurts like a bitch lol.
*
i normally use 1.2ohm coil,.. but after few refill,.. it'll go up to 1.4 or sometimes 1.5,..

and i use the lowest wattage,.. 6 watt,. lesser smoke, but save fluid and battery,..
SUSSpecial Agent
post Dec 14 2015, 04:39 PM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(Hamsom @ Dec 14 2015, 04:22 PM)
Meaning if i go max 50 watt on my Kbox Mini with vtc5 0.5 ohm. No problem leh? Just hot only? If so i have been misinformed. DAMN!
*
why use so low ohm ???.. if short circuit dangerous oh... higher ohm safer..
SUSSpecial Agent
post Dec 14 2015, 04:48 PM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(ThisIsAter @ Dec 14 2015, 04:42 PM)
0.5ohm is not that low by today's standard imo  hmm.gif
*
it's a heating device,.. not electronics,..
SUSSpecial Agent
post Dec 14 2015, 04:58 PM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(kuli2sahaja @ Dec 14 2015, 04:50 PM)
How would it short circuit unless there is something physically done to it? A short at 0.3 or 1.2 is the same, now a battery that vents is a different story
*
low resistance are prone to current hike,.. high resistance wud burn on high current, hence good for safety measure..

QUOTE(gunners_my @ Dec 14 2015, 04:53 PM)
yes.. with subohm everywhere... 0.5 is consider high...  laugh.gif  laugh.gif
*
ain't higher resistance give higher heat ??..
SUSSpecial Agent
post Dec 14 2015, 05:25 PM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(gunners_my @ Dec 14 2015, 05:09 PM)
opposite, bro... higher resistance lower hear... lower resistance higher heat... so, somewhere near 0.5ohm is consider safe for regulated mod.. I coil around 0.4-0.6 all the time... just nice...

btw... how can u vape at 6watt? my side, minimum 15watt... maximum 30watt... 6watt not going to get u the flavour real taste for sure...
*
no... tarak resistance mana ada heat ??... thats basic of electricity..

my mod max 50 watt.. min 6 watt,.. mech mode on 1.2ohm only 8-10 watt..
at 15 watt the juice taste funny liao,.. 20 watt got burned cotton carbon smell liao...
SUSSpecial Agent
post Dec 14 2015, 05:27 PM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(Roshie @ Dec 14 2015, 05:21 PM)
Last time I fired at 6w was on 2.2 ohm protank2, vamo mod. Those days are gone hehe

Need to know what device he's using.. Could b one with no step down. Or maybe 6w is still nice to some
*
high wattage form formaldehyde,.. bro

my mod is an ancient X-pro M65,...or maybe it's a cap palang one..

This post has been edited by Special Agent: Dec 14 2015, 05:28 PM
SUSSpecial Agent
post Dec 14 2015, 05:42 PM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(gunners_my @ Dec 14 2015, 05:30 PM)
bro.. the higher wattage achievable thanks to low resistance... for example, using 1.2ohm, u need around 4.5v to fire 20watt... but, if u are using 0.5ohm, it's only around 3.5V to achieve the same 20watt... if 20 watt burned out cotton with carbon smell.. those with 30-50 watt meletup already... anyway, I am talking from the perspective of regulated mod... not mech mod...
*
maybe u guys been using thicker coil,.. i'm using thin coil,.. i don't really fancy high wattage vaping,.. it's drain battery,..i only charge my mod few days once,..
SUSSpecial Agent
post Dec 14 2015, 05:46 PM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(gunners_my @ Dec 14 2015, 05:34 PM)
bro.. formaldehyde is not something confirm... even if it's confirm, two points... 1st, u shld fire above 5V in order to get that... 5V is equivalent to 40watt on my side... 2ndly, cigaratte has higher (roughly 100x) formaldehyde compares to vaping.. so, is formaldehyde a concern?  hmm.gif  hmm.gif  hmm.gif
*
it's the taste that i'm concern,..
SUSSpecial Agent
post Dec 14 2015, 05:55 PM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(gunners_my @ Dec 14 2015, 05:47 PM)
get a higher battery, bro.. for example... my eleaf istick 50watt ... with 10ml each day, my battery can last 4 days... again, it's about resistance... with lower resistance, u do not need to fire high in order to get high wattage... low ohm can easily fire lower voltage for higher wattage.. that's the theory...
*
wattage is the power,.. not voltage.. wattage/hour is the energy it got (power bank normally mAH which is the same)

bigger battery,.. berat...bro...

what ? 10 ml /day ???.. lulz.. i can't even finish 3ml for one day..

This post has been edited by Special Agent: Dec 14 2015, 06:02 PM
SUSSpecial Agent
post Dec 14 2015, 06:00 PM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(gunners_my @ Dec 14 2015, 05:49 PM)
if taste is the issue...u need higher wattage to get out the best taste... that's why we have mod supporting 100-200 watt these days..  nod.gif  nod.gif
*
i disagree, bro.. mine,.. if too high wattage got hangit kind of smell,.. hence i put it to lowest wattage..

but ,.. anyway different people different preference,..
SUSSpecial Agent
post Dec 14 2015, 06:04 PM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(duke_hunt @ Dec 14 2015, 06:00 PM)
i think ur mod doesnt have proper step down...

most probably ur mod automatically bypass the power regulator, which resulted in mech like firing..

it's happening with the newer ipv d2..
*
no,.. mech mode, it's on 8-10 watt on 1.2 ohm coil,.. wattage mode can step up or step down, by 0.01 watt each step, no matter what coil..

This post has been edited by Special Agent: Dec 14 2015, 06:07 PM
SUSSpecial Agent
post Dec 14 2015, 09:23 PM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(duke_hunt @ Dec 14 2015, 06:37 PM)
i dont think u understand my point bro..

but anyway, as long as u enjoy ur vaping experience, thats good to know..

oh, btw, am vaping at 13.5watts on my 1.2ohm coils, no burnt taste at all..
*
burn tastes at 20 watt,.. hangit at 15 watt.... when the coil aged, the resistance wud gone up to 1.4-1.5 ohm,..

for those who still arguing that lower resistance give u higher heat,.. pls read below,..

http://www.learnabout-electronics.org/Resi...sistors_01a.php

coil is a conductor, not insulator,.. hence it is POSITIVE TEMPERATURE COEFFICIENT,... hence i can fire up the coil even at low wattage b'cos of high ohm,.. where u guys who use lower ohm can't fire it up with low wattage,.. hence higher ohm is more energy saving for heating...
SUSSpecial Agent
post Dec 15 2015, 01:05 AM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(mi-g @ Dec 15 2015, 12:46 AM)
let say battery is freshly charged, at 4.2v. if i'm using 1.2ohm coil and fire at 12W, i can get good flavor but very little vapor. then i switch to 0.5 ohm fire at 25W i get both good flavor and lots of vapor

isn't this means lower resistance actually gives higher heat?

but yes on energy saving, higher ohm saves battery more than lower ohm

on other note, i can fire low ohm using low wattage but then no flavor and vapor
*
no.. u can't fire low ohm with low wattage,.. cos it won't generate sufficient heat to vaporize.. resistance is needed to vibrate the atoms to generate heat...

if lower resistance generate more heat, then why they don't use copper or gold as heating material ??.. they are lowest resistance in the world..

This post has been edited by Special Agent: Dec 15 2015, 01:15 AM
SUSSpecial Agent
post Dec 15 2015, 01:28 AM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(mi-g @ Dec 15 2015, 01:25 AM)
yes i know that... point is you can fire, but its useless  laugh.gif  laugh.gif
*
hence higher resistance higher heat with lesser power.. not lower resistance gets higher heat as u mention..
SUSSpecial Agent
post Dec 15 2015, 02:08 AM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(mi-g @ Dec 15 2015, 01:48 AM)
what i know is i get better vape by vaping 0.5ohm @ 25W than 1.2ohm @ 12W  laugh.gif  laugh.gif
*
try 1.2ohm at 25W,.. see wud burn cotton or not..

anyway,.. different people different preference..

This post has been edited by Special Agent: Dec 15 2015, 02:12 AM
SUSSpecial Agent
post Dec 15 2015, 11:26 AM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(TristanX @ Dec 15 2015, 08:23 AM)
I put 2 drops of vodka on my Mojito e-juice
*
i'm been wondering,.. if vape pure liqueur, would get drunk or not ??,.. or would it vaporize ?? hmm.gif

This post has been edited by Special Agent: Dec 15 2015, 11:26 AM
SUSSpecial Agent
post Dec 15 2015, 11:38 AM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(Vail @ Dec 15 2015, 11:33 AM)
flaming lamborghini  sweat.gif
*
really got liquor vape ??
SUSSpecial Agent
post Dec 15 2015, 11:42 AM

Getting Started
**
Junior Member
76 posts

Joined: Mar 2015


QUOTE(TristanX @ Dec 15 2015, 11:38 AM)
I don't think you wanna fill your lungs with huge amount of alcohol. That's the reason why I put only 2 drops.
*
it's vaporized, via lung so it's direct to blood stream,.. faster than stomach digesting..

so did u feel the buzz when vaping vodka ??

This post has been edited by Special Agent: Dec 15 2015, 11:42 AM

Bump Topic Topic ClosedOptions New Topic
 

Change to:
| Lo-Fi Version
0.0451sec    0.52    7 queries    GZIP Disabled
Time is now: 29th November 2025 - 07:10 AM