1). Resolution - set to highest resolution to have best video quality.
2). Loop recording - the video clip will be deleted base on first in first out basis. In the case of SD card full, the oldest video clip will be deleted. It is recommend to choose 3 minutes such that every video clip will be 3 minutes. 1 min will generate too many video clips, total 60 clips per hours. 10mins video clip will cause the video file size too big about 1GB per clip.
3). WDR(Wide Dynamic Range) - improves the video quality when light intensity is widely different.
4). Exposure - remain default value as below.
5). Motion Detection - set the motion to Off because vehicle is always moving when you driving, motion detect might cause you miss some scene when your vehicle pause at traffic light.
6). Record Audio - record audio inside your car, turn on or off base on your preference.
7). Gsensor - detect impact and protect the video clip from overwritten by loop recording. Gsensor prevent video clip being overwritten after accident. Activate Gsensor require you to regularly maintain the memory and manually remove the protected video clips. Set the Gsensor to high to reduce the maintenance effort.
P/S : If you do not want the effort to maintain the video clips, it is advisable to switch off the Gsensor.
8). Date Stamp - label the recording date in video clips.
9). Monitor Parking - when you switch on this the DVR will auto record when the DVR detected vibration during parking.
Below video demo the Car DVR auto record when it detect vibration :
10). Parking sensitivity - set the sensitivity of the sensor to detect the vibration as mentioned in Monitor parking setting. Please align the sensitivity base on your car requirement.
This post has been edited by nicety: Sep 27 2015, 01:20 AM
Aug 10 2015, 02:30 AM
Quote


0.0279sec
1.10
6 queries
GZIP Disabled