Welcome Guest ( Log In | Register )

563 Pages « < 541 542 543 544 545 > » Bottom

Outline · [ Standard ] · Linear+

> Aircon Discussion V3, Home Appliance

views
     
aurion
post Jan 7 2022, 08:24 PM

-=Sheer Driving Pleasure=-
*****
Senior Member
768 posts

Joined: Mar 2008
From: Kota Kinabalu, Sabah


QUOTE(clickNsnap @ Jan 6 2022, 08:20 PM)
Any one know the major different between the Panasonic CS-XPU10VKH and CS-XPU10WKH ?
*
I think XPU came out with WKH (without built in WiFi) first, before XPU XKH (with built in WiFi). There is no XPU-VKH as I can remember
iamsobloodysick
post Jan 7 2022, 10:57 PM

Regular
******
Senior Member
1,998 posts

Joined: Mar 2005
From: Truly Malaise
QUOTE(mini orchard @ Jan 6 2022, 06:41 AM)
As long the place is open, it should be ok. If you can share some photos, it will be easier to give some opinion.

If you intend to move it to the front, is there space to secured the compressor for safety purpose and if your unit is a highrise, will the management allow it to be place there ?

Secondly, are you ok if the wiring and piping to be joint for the new placement, if necessary ?
*
The daikin team said even though there are wide gaps on the grille, some hot air will still be blocked and circulate back to the ledge area. They proposed to duct out the compressor to lead hot air to the grille. But they will only do that if the cooling efficiency is affected by the placement.
ceo684
post Jan 9 2022, 12:21 AM

Component Burner
********
All Stars
10,772 posts

Joined: Jan 2003
From: Klang/Subang



QUOTE(iamsobloodysick @ Jan 7 2022, 10:57 PM)
The daikin team said even though there are wide gaps on the grille, some hot air will still be blocked and circulate back to the ledge area. They proposed to duct out the compressor to lead hot air to the grille. But they will only do that if the cooling efficiency is affected by the placement.
*
Leave a meter in front of the ODU fan will suffice.
This is Pana ODU clearance recommendation:




Attached thumbnail(s)
Attached Image
ycs
post Jan 13 2022, 10:30 AM

MEMBER
*******
Senior Member
3,567 posts

Joined: Jan 2003
From: Selangor



my 2yo pana 1hp inverter got gas leak at indoor cooling coil, is it worth changing to new coil? cost about RM500 to replace or better buy new sweat.gif
mini orchard
post Jan 13 2022, 11:41 AM

10k Club
********
All Stars
11,537 posts

Joined: Sep 2017
QUOTE(ycs @ Jan 13 2022, 10:30 AM)
my 2yo pana 1hp inverter got gas leak at indoor cooling coil, is it worth changing to new coil? cost about RM500 to replace or better buy newΒ  sweat.gif
*
Confirmed cooling coil from technician ? or is it the piping joints ?

Rare case if is indeed from the coil.

What I will do ...if is indeed the coil, then I will buy a complete 2nd hand unit and keep the current for spare parts.

Attached Image

This post has been edited by mini orchard: Jan 13 2022, 11:46 AM
ycs
post Jan 13 2022, 11:58 AM

MEMBER
*******
Senior Member
3,567 posts

Joined: Jan 2003
From: Selangor



» Click to show Spoiler - click again to hide... «

i can hear hissing and smell the gas from indoor unit; maybe its the joints, haven't called anyone to check yet
mini orchard
post Jan 13 2022, 12:40 PM

10k Club
********
All Stars
11,537 posts

Joined: Sep 2017
QUOTE(ycs @ Jan 13 2022, 11:58 AM)
» Click to show Spoiler - click again to hide... «

i can hear hissing and smell the gas from indoor unit; maybe its the joints, haven't called anyone to check yet
*
Try to check just below the casing or wall for any signs of dripping oil.
incredibless
post Jan 15 2022, 02:09 AM

Casual
***
Junior Member
335 posts

Joined: Jun 2012
For those who are using Pana X-Deluxe model. Do you guys face the cooling not as good as regular non inverter units? I have one 1.5hp and in terms of cooling with temp 23-24c and fan speed 2bars. The cooling is just so so vs my another 1hp regular non inverter pana where 24/25c can feel the coldness already. Any idea?
ceo684
post Jan 15 2022, 03:46 AM

Component Burner
********
All Stars
10,772 posts

Joined: Jan 2003
From: Klang/Subang



QUOTE(incredibless @ Jan 15 2022, 02:09 AM)
For those who are using Pana X-Deluxe model. Do you guys face the cooling not as good as regular non inverter units? I have one 1.5hp and in terms of cooling with temp 23-24c and fan speed 2bars. The cooling is just so so vs my another 1hp regular non inverter pana where 24/25c can feel the coldness already. Any idea?
*
Inverter temp is true temp. Ur non is overcooling.
mini orchard
post Jan 15 2022, 06:00 AM

10k Club
********
All Stars
11,537 posts

Joined: Sep 2017
QUOTE(incredibless @ Jan 15 2022, 02:09 AM)
For those who are using Pana X-Deluxe model. Do you guys face the cooling not as good as regular non inverter units? I have one 1.5hp and in terms of cooling with temp 23-24c and fan speed 2bars. The cooling is just so so vs my another 1hp regular non inverter pana where 24/25c can feel the coldness already. Any idea?
*
Firstly, since both are different hp, I believed the room size is also different. The 1.5 could be in an open space and the 1 hp in an enclosed room.

Secondly, is possible the 1.5 hp is undersized to room space. So the ac cannot achieved the 'set' temperature.

Thirdy, the right way to know the temperature is to use a thermometer. Place 1 in each room and away from the blower direction.
incredibless
post Jan 15 2022, 05:06 PM

Casual
***
Junior Member
335 posts

Joined: Jun 2012
QUOTE(mini orchard @ Jan 15 2022, 06:00 AM)
Firstly, since both are different hp, I believed the room size is also different. The 1.5 could be in an open space and the 1 hp in an enclosed room.

Secondly, is possible the 1.5 hp is undersized to room space. So the ac cannot achieved the 'set' temperature.

Thirdy, the right way to know the temperature is to use a thermometer. Place 1 in each room and away from the blower direction.
*
Yes. Both are two different area the 1.5hp is in the master room and 1hp is in back room. Since is already install, what are the ways to make it cool? I notice is when upon turn on before sleep i feel is cooling but after midnight 3-4pm the aircond blower stops and this is where i feel hot.πŸ˜…. Can i Dail the temperature lower? Increase the fan speed? πŸ€” if colder that would defeat the purpose of energy savings.
mini orchard
post Jan 15 2022, 05:54 PM

10k Club
********
All Stars
11,537 posts

Joined: Sep 2017
QUOTE(incredibless @ Jan 15 2022, 05:06 PM)
Yes. Both are two different area the 1.5hp is in the master room and 1hp is in back room. Since is already install, what are the ways to make it cool? I notice is when upon turn on before sleep i feel is cooling but after midnight 3-4pm the aircond blower stops and this is where i feel hot.πŸ˜…. Can i Dail the temperature lower? Increase the fan speed? πŸ€” if colder that would defeat the purpose of energy savings.
*
Does the cooling mode restarts after sometime or it remains the same till you off ?

This post has been edited by mini orchard: Jan 15 2022, 05:54 PM
incredibless
post Jan 15 2022, 08:50 PM

Casual
***
Junior Member
335 posts

Joined: Jun 2012
QUOTE(mini orchard @ Jan 15 2022, 05:54 PM)
Does the cooling mode restarts after sometime or it remains the same till you off ?
*
I didnt really take note but if i adjust the temperature from 24 to 23c then the blower starts again. Otherwise it just maintain without any blower sound.
mini orchard
post Jan 15 2022, 10:48 PM

10k Club
********
All Stars
11,537 posts

Joined: Sep 2017
QUOTE(incredibless @ Jan 15 2022, 08:50 PM)
I didnt really take note but if i adjust the temperature from 24 to 23c then the blower starts again. Otherwise it just maintain without any blower sound.
*
I suspect it could be copper / room sensor problem. If you know diy, then unplug the sensor pin from the module and plug in again to try. Otherwise, you need to call the technician.

Attached Image
myteam94
post Jan 16 2022, 01:24 AM

Getting Started
**
Junior Member
274 posts

Joined: Oct 2009
Guys

I'm currently surveying an aircon for living room, budget within RM 2000 (possible wanna make sure of save 3.0 discount)

My current bedroom is using Samsung 1.0HP inverter (SAM-AR10TYHY) - was suggested by salesperson biggrin.gif
A year of usage, so far is okay and cool enough for small apartment bedroom

So wanna ask opinion whether should I go same brand or find other brand

I'm leaning toward panasonic xdeluxe inverter 1.5HP as the price is within budget and it has some extra feature (wifi capability).

is this model recommended?
mini orchard
post Jan 16 2022, 06:07 AM

10k Club
********
All Stars
11,537 posts

Joined: Sep 2017
QUOTE(myteam94 @ Jan 16 2022, 01:24 AM)
Guys

I'm currently surveying an aircon for living room, budget within RM 2000 (possible wanna make sure of save 3.0 discount)

My current bedroom is using Samsung 1.0HP inverter (SAM-AR10TYHY) - was suggested by salesperson biggrin.gif
A year of usage, so far is okay and cool enough for small apartment bedroom

So wanna ask opinion whether should I go same brand or find other brand

I'm leaning toward panasonic xdeluxe inverter 1.5HP as the price is within budget and it has some extra feature (wifi capability).

is this model recommended?
*
You wont go wrong with Pana brand.
incredibless
post Jan 16 2022, 07:15 AM

Casual
***
Junior Member
335 posts

Joined: Jun 2012
QUOTE(mini orchard @ Jan 15 2022, 10:48 PM)
I suspect it could be copper / room sensor problem. If you know diy, then unplug the sensor pin from the module and plug in again to try. Otherwise, you need to call the technician.

Attached Image
*
Thanks. You mean i just remove and plug back the sensor pin? I think I roughly know what u mean is easily seen from the coil right? Standard size? Can i get your number? πŸ˜ƒIf u can guide me would be great.

This post has been edited by incredibless: Jan 16 2022, 07:51 AM
mini orchard
post Jan 16 2022, 08:36 AM

10k Club
********
All Stars
11,537 posts

Joined: Sep 2017
QUOTE(incredibless @ Jan 16 2022, 07:15 AM)
Thanks. You mean i just remove and plug back the sensor pin? I think I roughly know what u mean is easily seen from the coil right? Standard size? Can i get your number? πŸ˜ƒIf u can guide me would be great.
*
Yes, sometimes it works. Otherwise buy a replacement. Is cheaper than calling a technician.

Take a photo of the pin just in case you need to buy a replacement.

Attached Image

Ignore the circle that shows the flap motor.

The pin head is located at the other circle.

UNPLUG THE SWITCH OR TURN OFF THE MAIN if you intend to diy. You need to remove the wire connection to access the pin. Take photo of wire connection b4 removing in case you forgot about which wire goes to which port.

This post has been edited by mini orchard: Jan 16 2022, 08:58 AM
sleyer
post Jan 16 2022, 10:04 AM

Enthusiast
*****
Senior Member
730 posts

Joined: Apr 2007
Aircond for living area should be non inventer rite? 1.5hp or 2hp?
mini orchard
post Jan 16 2022, 10:20 AM

10k Club
********
All Stars
11,537 posts

Joined: Sep 2017
QUOTE(sleyer @ Jan 16 2022, 10:04 AM)
Aircond for living area should be non inventer rite? 1.5hp or 2hp?
*
Go for 2 hp. Easier to control temp and fan speed. Faster cooling.

563 Pages « < 541 542 543 544 545 > » Top
 

Change to:
| Lo-Fi Version
0.0479sec    0.66    6 queries    GZIP Disabled
Time is now: 3rd July 2022 - 08:03 PM