Outline ·
[ Standard ] ·
Linear+
***LYN Official Kia Cerato K3 Owners Club V2***
|
joshua_chin
|
May 30 2016, 02:01 PM
|
Getting Started

|
hello guys, does anyone encountered the same situation as mine?
usually i set my aircond to 23C (single zone and non automatic fan speed), however intermittently will feel the air coolness level is uneven coming out from random vents. sometimes even warm air coming out. if the temp sets to 21c or lower, the air is chilling cold. does anyone encountered this problem before?
i tried to set to 23c this morning, the temp on left vent is higher compares to right. set to 21c and chilling on both sides. so i set to 24c and 23c to check the coolness, 24c feel cooler than 23c.
|
|
|
|
|
|
joshua_chin
|
Jun 3 2016, 06:33 PM
|
Getting Started

|
QUOTE(Motorman @ May 26 2016, 05:02 PM) KIA cars today have very little mechanical problem. However being a modern car it have more programs and sensors. In this case the car was indicating that the abs and esc were not working properly and reminding the driver to get the car check which is good. Most car just need a good calibration and some just have to get the effected sensor replaced or cleaned. I could not agree with the statement where Kia vehicles have very little mechanical problem. most Cerato owners facing engine vibrate issue (2.0 caused by alternator pulley, 1.6 yet pending for solution since July 2013), driver seat vibration (screws not tighten within the seat assembly, seat spring net not fitted firmly, seat track gear loose etc etc), the air vent fin failed to adjust due to loose, dashboard rattling sound etc etc.......
|
|
|
|
|
|
joshua_chin
|
Jun 11 2016, 06:59 AM
|
Getting Started

|
QUOTE(eyedropz_TT @ Jun 8 2016, 05:03 PM) i facing this issue as well... especially the side air vents... any solution? i logged complaint to HQ about this issue, so far has no feedback from them yet.
|
|
|
|
|
|
joshua_chin
|
Jun 11 2016, 07:04 AM
|
Getting Started

|
QUOTE(ArepAltair @ May 30 2016, 04:47 PM) i think i felt the same thing too... need to check using ur method... hmmm... do update us on your finding ya....
|
|
|
|
|