yeap. most probably.if not u can get very high quality+clear videos of u completing the VIPER!
Actually i have edited full length of viper video. but some of footage were too dark due to very very bad low light condition. not dare to share... after post nobody want to buy yi camera later..
This post has been edited by devilkid84: Jun 2 2015, 01:51 PM
my first bulk just arrived, IMO, kingma OEM case quite rugged and solid! the case quite thick and wont bend and most important no vignette at corner when taking picture
haven get under water yet
» Click to show Spoiler - click again to hide... «
not sure my zapbalang brand casing got any third party red filter for diving available or not. the kingma casing's len part is square, yi original is round which i "think" same as my zapbalang brand casing.
This post has been edited by devilkid84: Jun 15 2015, 12:02 PM
the one u bought is what zapbalang brand? maybe wait till the ori case have lens filter then u can use as well?
most likely got to wait since i won't go any diving for this year. conclusion: yi ori casing lens = round my zapbalang brand = round telesin = round kingma = square
what else brand for casing in the market now that I missed out?
hmm. i think wont effect much also if dint use filter cause the software can adjust the color aldy.
never tried to use software to tune back to original color. boleh ke? all the while using gopro with red filter for diving. if dont pakai the video and picture totally bluish.
wow the red plastic filter cost 100 buck!? i bought the one for kingma for <5
last Saturday helping my fren look for red filter for gopro 3 at 1utama, pwtc (dive fair) and lowyat. The cheapest i can find is around 100 (again zapbalang brand). those well-known third party also cost 120 above. if original gopro cost more than that. anyway just a plastic cover, don know why selling so expensive.
wow.. i think my zapbanglang brand was reviewed by him too. The second casing. like what he had commented: "The camera fits well into the case and it is very hard to get it out again. The cap easily detaches from the metal bar. I noticed that it is sealed, but there is a larger gap on one side of the case, which could or should be tighter (last photo)." But I didn't notice any vignetting problem. later go home double check again.
looks like 1.2 hardware firmware got alot of issues reported. Better stay away first. btw, android app got v1.8 updates. just check the app it prompt out updates. I guess it should be accomodate for 16:9 photo for the latest 1.2 firmware.
after my phone updated to mashmallow v6.0, i found difficulties to connect camera again. even if successful connected, cannot load the image from the camera via the phone. Any idea?