4.7Ghz, 5.0Ghz on Turbo I think. Meh, stupid nonsense processor. 220W.

It was the worse processor on my book, until I received the FX-9370 the other day. FX-9370 is even worse than the FX-9590.

Haha off-topic a bit now but anyway yeah, FX processors are hot, crazily hot. That also you should see the power draw off the wall, it's just insane.

My favorite now is the FX-8320E. Nothing else.

Yoh....Bro bro sekalian, I have solved the problem!
The auto clocking by my Asrock motherboard tune the cpu voltage to 1.35, and looking for 3.2Ghz only. Well this voltage is ridiculously high.

I then set my clocking to manual, then set the voltage to 1.15v (1.10v screen will freeze or blue screen i forgot). Now since the temperature goes down, and never exceed 70'c at 100% performance. So my clock speed runs at 3.2Ghz nicely, just occasionally will dropped to 2.8Ghz but goes back to 3.2ghz very soon.

Frankly, I don't dare to OC it because It already running water cooling, and it barely can maintain the temp' below 70'c. 3.2 is better than 1.4 absolutely...

Me too using Fx8320e. Hoping the 6th gen AMD technology wont disappoint me, heard the TDP is around 15-35W. Maybe the heat problem might goes down dramatically?

Some AMD product rocks actually, if you consider the technology and all they're really doing very well.

It's just in Malaysia the pricing kinda sucks so it becomes less value proposition.

Their FX processor is dated but the APUs are actually filled with technology. The capability not harnessed as the technologies are new.

here's a stock fx8320 with some undervolt, cooled by hyper 212+ @ pushpull... given d temp, i didn't dare to clock it...

You disappoint me senpai!

Of all people, you should be overclocking it laaaaa.

He's pushing the limit of the power supply already. 12V rail fluctuating quite bad

His 12V rail is alright actually. It's within the 12V rail standard and the max / min reading (though innaccurate via software) doesn't even show bad fluctuation.

dont really dare & time constraint sir... usin a chap ayam CM pcar serie 650w watter, quite bad +12v rail to me on load. there's some headroom for oc given d temp but i dont wanna stress d pwm too much since i didn't put a 120mm fan coolin it. 3.8GHz should be fine i guess, but i doubt i can keep d vcore @ 1.2v...

cap ayam psu sure bad under load bro...

never noticed that but when i see d rail under load d no is quite bad to my standard... thou like what u said sir sw monitorin is never accurate...

will give it another run mebe on friday since it's PH over here... if no other activity ofcoz... mite end up watchin Barney/Elmo d whole day thou...

Thank for share