Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed
126 Pages < 1 2 3 4 5 > » Bottom

Outline · [ Standard ] · Linear+

 LYN Proton INSPIRA Owners and Fans Thread V67!, Source of low traffic: goo.gl/ZRQcSd

views
     
ffrulz
post Mar 3 2015, 04:59 PM

Over the hills and far away.
*****
Senior Member
995 posts

Joined: Mar 2005
From: Johor Bahru , Johor , Malaysia
QUOTE(mytmnet @ Mar 3 2015, 04:47 PM)
Just check my car engine oil level, is at low marking there (parked for one week), is that normal?
And when I try to top up... OMG... the cap can't open, any idea to open it? icon_question.gif
*
Can open but super tight. I take the back of the screwdriver and keep knocking on it until it open.
botack
post Mar 3 2015, 05:05 PM

Casual
***
Junior Member
349 posts

Joined: Jan 2008
From: Puchong/Sunway/Subang Jaya/Shah Alam/Klang
QUOTE(mytmnet @ Mar 3 2015, 04:47 PM)
Just check my car engine oil level, is at low marking there (parked for one week), is that normal?
And when I try to top up... OMG... the cap can't open, any idea to open it? icon_question.gif
*
did you start your car? if you have not. then it is normal. gravity ma. oil also will drop at the oil pan lor.
Kirie
post Mar 3 2015, 09:16 PM

New Member
*
Junior Member
16 posts

Joined: Apr 2008
QUOTE(ffrulz @ Mar 3 2015, 04:59 PM)
Can open but super tight. I take the back of the screwdriver and keep knocking on it until it open.
*
put towel on the cap, open it using plier..walla....
mytmnet
post Mar 3 2015, 10:29 PM

Getting Started
**
Junior Member
133 posts

Joined: May 2008
QUOTE(botack @ Mar 3 2015, 05:05 PM)
did you start your car? if you have not. then it is normal. gravity ma. oil also will drop at the oil pan lor.
*
Just start the car then hit the lowest point rclxub.gif
Then fill up 500ml to it shocking.gif

QUOTE(ffrulz @ Mar 3 2015, 04:59 PM)
Can open but super tight. I take the back of the screwdriver and keep knocking on it until it open.
*
I got to open it by spanar at last sweat.gif

QUOTE(Kirie @ Mar 3 2015, 09:16 PM)
put towel on the cap, open it using plier..walla....
*
Ya lor o... I just try towel with hand but fail.
Next time like this I will try towel with spanar tongue.gif


T630
post Mar 4 2015, 01:25 AM

On my way
****
Senior Member
572 posts

Joined: Jan 2003
From: Puchong

fuyoh... lagi new tered... rclxms.gif
ckdenion
post Mar 4 2015, 08:34 AM

Financial Practitioner
*******
Senior Member
2,866 posts

Joined: Sep 2008
From: Wangsa Maju, KL
QUOTE(mytmnet @ Mar 3 2015, 10:29 PM)
Just start the car then hit the lowest point  rclxub.gif
Then fill up 500ml to it shocking.gif
*
from lowest point...top up 500ml also not enough what. what is the oil level after u start the car and let the engine run for a while?
nickken
post Mar 4 2015, 09:22 AM

New Member
*
Junior Member
36 posts

Joined: May 2006
From: Malacca
wooo.... new thread..... biggrin.gif
iksern
post Mar 4 2015, 10:58 AM

New Member
*
Junior Member
26 posts

Joined: Sep 2010
From: saya buta jalan
wahh v67 shocking.gif

i guess no other car threads last longer than this...

correct me if i'm wrong... notworthy.gif notworthy.gif notworthy.gif
edison1437
post Mar 4 2015, 11:05 AM

Enthusiast
*****
Senior Member
819 posts

Joined: Jun 2007
From: Moon's Dark Side
QUOTE(iksern @ Mar 4 2015, 10:58 AM)
wahh v67  shocking.gif

i guess no other car threads last longer than this...

correct me if i'm wrong...  notworthy.gif  notworthy.gif  notworthy.gif
*
got..... also proton doh.gif
Damascus
post Mar 4 2015, 11:24 AM

New Member
*
Newbie
1 posts

Joined: Nov 2008
Hidup, lyn inspira. The longest trolling forum business and other serious matters. LLP. thumbup.gif rclxms.gif

This post has been edited by Damascus: Mar 4 2015, 11:30 AM
iguana_tan
post Mar 4 2015, 11:45 AM

New Member
*
Newbie
3 posts

Joined: May 2011
just becoz tis car got never ending problem... unsure.gif
QUOTE(iksern @ Mar 4 2015, 10:58 AM)
i guess no other car threads last longer than this...
correct me if i'm wrong...  notworthy.gif  notworthy.gif  notworthy.gif
eugenetwh
post Mar 4 2015, 12:47 PM

On my way
****
Senior Member
675 posts

Joined: May 2009
So i went to Showroom lepak few days back. KNS that SA budak baru kot. tell me Inspira is using Lotus Engine. doh.gif doh.gif
jtan3633
post Mar 4 2015, 12:47 PM

Getting Started
**
Junior Member
228 posts

Joined: Mar 2005
Hi all!!

Looking at getting the 1.8 manual.

Any feedbacks about this car? Both good and bad?

Is it still a Mitsu Mivec engine?

Thanks all
eugenetwh
post Mar 4 2015, 12:49 PM

On my way
****
Senior Member
675 posts

Joined: May 2009
QUOTE(jtan3633 @ Mar 4 2015, 12:47 PM)
Hi all!!

Looking at getting the 1.8 manual.

Any feedbacks about this car? Both good and bad?

Is it still a Mitsu Mivec engine?

Thanks all
*
endless problem. lose to vios n myvi. what else? btw it is using campro and Lotus engine now.


troll mode off. yes mitsu mivec engine. same like lancer.
mytmnet
post Mar 4 2015, 12:50 PM

Getting Started
**
Junior Member
133 posts

Joined: May 2008
QUOTE(ckdenion @ Mar 4 2015, 08:34 AM)
from lowest point...top up 500ml also not enough what. what is the oil level after u start the car and let the engine run for a while?
*
No big difference, at the lowest point and higher a little bit after run a while.
After top up 500ml is above 1 cm only, but my appointment with proton at monday so consider no issue. smile.gif
K3nnYkl82
post Mar 4 2015, 12:52 PM

NewBie
*******
Senior Member
2,479 posts

Joined: Jan 2003
From: Mars
Mitsu salesman told me proton insapla engine use lower grade piston. Good luck
eugenetwh
post Mar 4 2015, 12:58 PM

On my way
****
Senior Member
675 posts

Joined: May 2009
QUOTE(K3nnYkl82 @ Mar 4 2015, 12:52 PM)
Mitsu salesman told me proton insapla engine use lower grade piston. Good luck
*
maybe its true. i somehow accidentally read your Insapla to LapsapCar sweat.gif
ckdenion
post Mar 4 2015, 01:35 PM

Financial Practitioner
*******
Senior Member
2,866 posts

Joined: Sep 2008
From: Wangsa Maju, KL
QUOTE(eugenetwh @ Mar 4 2015, 12:47 PM)
So i went to Showroom lepak few days back. KNS that SA budak baru kot. tell me Inspira is using Lotus Engine.  doh.gif  doh.gif
*
bukan campro engine ka? tongue.gif

QUOTE(jtan3633 @ Mar 4 2015, 12:47 PM)
Hi all!!

Looking at getting the 1.8 manual.
still got stock?as i know quite hard to find stock...if got then good, got discount for 2014 model

Any feedbacks about this car? Both good and bad?
no comment yawn.gif

Is it still a Mitsu Mivec engine?
YES

Thanks all
*
QUOTE(K3nnYkl82 @ Mar 4 2015, 12:52 PM)
Mitsu salesman told me proton insapla engine use lower grade piston. Good luck
*
bulk piston from mitsu engine... tongue.gif
woe.com
post Mar 4 2015, 01:51 PM

Casual
***
Junior Member
438 posts

Joined: Dec 2004
QUOTE(jtan3633 @ Mar 4 2015, 12:47 PM)
Hi all!!

Looking at getting the 1.8 manual.

Any feedbacks about this car? Both good and bad?

Is it still a Mitsu Mivec engine?

Thanks all
*
is a mivec engine, and for those who love the car will always love it, feedback for the car ahh, u need to read back from V1 post jor, but most important is base on yrself whether you will regret or not since the badge is wat all ppl looking at. To be very honest, from the time when I brought the car till now, no 1 even interested to ask more about the car or take a look. So pls have this prepare in mind before u feel like ppl tot u syok sendiri.
edison1437
post Mar 4 2015, 02:00 PM

Enthusiast
*****
Senior Member
819 posts

Joined: Jun 2007
From: Moon's Dark Side
QUOTE(K3nnYkl82 @ Mar 4 2015, 12:52 PM)
Mitsu salesman told me proton insapla engine use lower grade piston. Good luck
*
my friends saw my car and said inspira interior different than mitsu whistling.gif
« Next Oldest · Car Clubs · Next Newest »
 

126 Pages < 1 2 3 4 5 > » Top
Topic ClosedOptions
 

Change to:
| Lo-Fi Version
 0.0215sec    0.25    6 queries    GZIP Disabled
Time is now: 8th December 2025 - 06:04 AM
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Removal Request
Powered by Invision Power Board © 2025  IPS, Inc.