I think this is normal, before engine starts, the pedal are stiff, once the engine started, it loosen up to normal driving pressure, so when you step hard on it, once you start the engine, of course the pedal will go further.

Nope. Mine is E spec and can't be off if the gear is in N.

Not sure, but Skeletonman mentioned cannot, so must be cannot. Anyway, if you try to lock car with engine on, it won't lock...been there done that...was outside one day, raining a bit, can't hear engine either, thought off already, then cannot lock car....LOL.

V spec, can turn off engine in position N. But, instrument panel will ask to put gear in position P after turning off engine in N.
Guess E spec should be the same

E spec encountered the same respones as above..i tried 

dint quite get u... did u mean the noise our car make when the alarm sounds?

I'm not sure what is the right way.
Maybe we can wait sifu here to explain what is the correct way with Push start button. 

Press the brake and press the start button. Wait till the blue light to goes off then only drive.

My fren told me if start car directly without push button twice one day it will damage your ECU.. My fren car is preve mybe the problem happen to proton not honda but need to alert also right.. 😀

true as well.. warranty inclusive of labour and product replacement? went kah motor that day engineers say one CVT replacement was done as total failure of the gear box happened, but didn't ask about the cost of labour and etc..

never mention at most less than 1 year since launched in Msia.. engineer say CVT gearbox fail oh ..

probable

Not much different. Please take note as 6% GST is applicable on your downpayment as well as car loan. In total still expensive than pre-GST purchased the vehicle.