best you say ? wait till imos 3d corning release. 

Can someone tell me about this ringke case?
http://www.amazon.com/gp/aw/d/B00MJA3Q1Y/r...8195670-9156234

i just ordered a jabra Play bluetooth... should reach tmr.. will provide feedback tomorrow.
yes.. 1 bar gone unless you are in very strong coverage area, then no effect.
just use your nail, lift a bit on the side (not corner), and use a pen to slowly push it out. Do not let go your hand before you push out the air. Then it should be good..
(i find the installation of 3D Corning is pretty easy once you get the grip on how to install it. My first piece took more than 3 days to fully remove the bubbles. Now it took less than 10 mins to perfectly install one)

Looks like the exact same defect I had. The replacement piece fit perfectly and easily.

A lot better than expected, still admire it each time I look at it. Maybe it has to do with it being a darker color but I don't notice any discoloration so far.
I went to connect2u's installer in lowyat to verify that it was indeed a defect and they sent out a replacement straight away. If you look at my posts a few pages back I posted a picture of the exact same thing. Will send the defect back to them on Monday for them to claim from imos .

[attachmentid=4334950]

Mine more jailat

I had the same issue when I installed yesterday. After pushing and holding it, I manage to get the whole side to stick on. Now everything is perfect. Took me almost half an hour just push and hold the side to make it stick.

Yes , Imos taiwan ship me another new one after I show them the picture

no adhesive on the side.. if got then will have serious trouble in getting the air out.
We noticed most of those experienced installer have issue with the 3D installation. You cannot apply based on your current knowledge on applying the normal sp due to the curved edges of the corning glass.
Why use bare hand? In all the videos we have been showing the use of a pen to push out the bubbles.. We wont say it's defect cos we are installing the same batch here too.. and all of them are perfectly installed. We do not encourage replacement as it will cost you RM10 to send it back here and another RM10 for us to send it back to you, not to mentioned of the inconvenience caused along the way. And dont forget we have to send back to Taiwan for the replacement too. We have been absorbing all the cost but if our currency do not improves, we might not be able to continue to offer direct replacement but to wait for Taiwan to replace it.

Finally a feedback on UAG cases... too bad.. but for Thule series, it's compatible ... (personally tested in the shop)
As what S4a mentioned, you might consider it a defect if you install it like any other glass sp. A lot of people forgotten that they are paying for the premium quality which includes the 3D Curved Corning Gorilla Glass on the edges too. if you have checked out how corning is made, you will realised that the compression is very high and thus you dont find much space for air to flow out.. The fitting of the glass to your phone is very precise, hence once attached, air bubbles are trapped in between. It will takes patience and efforts to remove even if you are a pro in installing other glass sp.
Even myself spent a lot of sleepless nights trying to figure out what is the best and effective ways to install it. (no easy way out i guessed..)
But in INGfusion case, since he ordered from Taiwan, he might get the older version instead of the new one. HK and Taiwan and China earlier batches got adhesive issues which has been resolved. If you purchased from us and you think your unit is defected, kindly contact us too.