actually 1 12" woofer ned how many amp???n need how many channel d amp 2 blow the mid n speaker???tq.....

4 channels will do

bridge 2 channels to drive the 12"
use the remaining 2 channels to drive ur mid and tweeter with xover (assume u have the component speaker)

a sub need one channel from your amp... either you bridge 2 ch to 1 ch or jus use 1 ch...

Just a good 4 channel will do. Just test out the RMS is really sufficient, as it state in the technical spec or manual. 75w x 4ch will be good enough.

Another option is direct the component set from HU, and a 2ch amp for sub-woofer.

A lot of way to push your woofer..:
- use monoblok amp
- bridge your 2 channel amp
- bridge 2 of 4 channel amp....

erm...then wat brand speaker best???component set mean wat????

i think using a single dedicated amp like the monoblock is better

speaker there is sound stream, MB Quart, RockFord Fosgate, Kicker, DLS and Focal.

btw the way im selling all this...

This post has been edited by Torniquet: Aug 30 2006, 10:53 PM

Can't say what brand speaker best...
Depend your budget lo... how many budget you spend, you can get the best speaker at that range...

Component set = mid-speaker + crossover + tweeter

what speaker is almost cannot 'koyak'? or got warranty if koyak...

every speaker will not koyak if you use them the proper way... if it says 50W rms and you feed them 200W rms then sure koyak... or when you use tweeter to play as low as 100Hz then sure koyak lo...

if you use them with care then sure it will never be koyak...

cheers...

erm...then wat the mean by component set n speaker???i quite blur

component comes in a set... 2way comes with a pair of tweeters, passive crossovers and mids.... while three way will got another mid-range speaker added to the pakage lo....

and speaker... well they are jus speakers...

cheers...

tq bro...then which 1 better??????

I would recommend sticking to a 2-Way as it'll be easier to be installed and made to sound good.

A 3-way would need very good driver placement and settings to make it sound good.

2 way / 3 way also base on what car you drive, as some car placement of 3 way really sound lousier then 2 way...

3 way need positioning & alignment too..
Difference car difference location tweeter & mid...
No much people can really got it...

Ya Ya, start with 2 way. Really big head with 3 way. I'm using 3 way, still can't get a perfect position.

Choosing speaker and amp look for matching and like for a like.

Bro, you want play ice liao meh? Ur magnat sold edi?
This guy play SPL.. Cannot get 4 channels amp to bridge the woofer..
Buy 4 channels amp to power 2 sets of component ( front and rear ).. Then a monoblock amp to power ur 2pcs x 12" woofer.. Tat will give u enuff vocals n most important.. BASS.. !

tq bro....i havent sold it...wana put at dad car mah...haha