JBL LSR308 . You won't regret.
PC Audio Need Recommendation on Active Studio Speaker 2.0
|
|
 Sep 21 2014, 09:46 PM
Return to original view | Post
#1
|
 
All Stars
10,475 posts Joined: Jan 2003 From: Sarawak 
|
|
Quote|
|
|
|
|
Sep 27 2014, 09:14 PM
Return to original view | Post
#2
|
|
All Stars
10,475 posts Joined: Jan 2003 From: Sarawak
|
QUOTE(asunakirito @ Sep 27 2014, 12:03 AM) Do you know who sells them? Seems kinda rare locally. You can try to contact Mahajak Trio, our local JBL distributor. I couldn't find out the local price, but on ebay.com, its priced at RM3300  On amazon.com, priced around $200 USD, so it would be approximately RM651 (not including shipping + gov 10% tax)  |
|
|
Dec 25 2014, 09:35 AM
Return to original view | Post
#3
|
|
All Stars
10,475 posts Joined: Jan 2003 From: Sarawak
|
QUOTE(ktek @ Dec 24 2014, 06:14 PM) r1600 is small, unable to cover full range sound especially bass side. That frequency can be played but at very low SPL. Besides that, the amp will be distorted and the sound will not be very clean. That's why we have subwoofer for that.actually u can look at the specs, 4" cone usually cover about 80, 90 100 hz 5.25" can go near to 60,70hz 6.5" can go 50hz 8" even better To cover full range (20Hz-20KHz), you need lot's of power and big woofer (>12"). |
|
|
Dec 25 2014, 09:36 AM
Return to original view | Post
#4
|
|
All Stars
10,475 posts Joined: Jan 2003 From: Sarawak
|
QUOTE(MunDsuM @ Dec 17 2014, 05:29 AM) I'm looking to get the LSR305. Make sure your source has pro level output, else you'll get hiss/noise. |
|
|
May 9 2015, 04:47 PM
Return to original view | Post
#5
|
|
All Stars
10,475 posts Joined: Jan 2003 From: Sarawak
|
QUOTE(whatsayyou @ May 9 2015, 02:37 PM) Can define pro level output? pro gear normally use XLR with higher driving voltage.I'm intending to get a set of 2.0 speakers for my desktop. Only got onboard soundcard (http://www.asrock.com/mb/Intel/Z77%20Extreme3/ Realtek ALC892) Looking at JBL LSR305. I believe i need additional items in order to connect it to the pc? if u link a consumer gear source (giving low voltage) to pro gear amp (expecting to receive high voltage), the pro gear amp gets that very little signal & amplifies that small signal with all the noise. this is bad due to poor gain matching, reducing signal-noise-ratio. |
| Change to: |  0.0224sec
 0.38
 6 queries
 GZIP Disabled
Time is now: 8th December 2025 - 02:09 PM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.