Hi..yesterday I cut the fan cover for front n top panel..this time using jigsaw..haha   measurement 150mm x 300mm with 6 holes each pieces..



I don't what it is called..but I bought it at the electrical shop..this will be the standoff between the fan cover and the panel..will be cut into half..



Not equally same height..huh..might need some filing..hmmm maybe will paint it flat black later on..it is made of copper with chrome coating..



Here is the almost complete part..I'm using the 6 x 35mm of M4 screws..hopefully it will be able to penetrate through the 10mm thickness front panel..



Buy here come the challenging part..huuuuhh how am I going to drill with all the coolant and loop still intact..   hahaha Challenge of Reverse Engineering..hahaha 

Stay tuned..

Hello guys..

Just little update on the fan cover..I already place the masking tape and holes marking onto the top fan panel.. see the red square box..hehe lazy workpiece..



Plus need to place something to act as the debris cover from the drill operation..I have to dismantle the LED strip under the top panel before I start drilling..



Anyway the top panel fan cover went well..all the standoffs fit the holes nicely..



Then finish with the front panel also..huhh quite a relief its all went very well..    



Previously I decide to paint the standoff with flat black paint..but I this it still nice to have it in silver..haha

This is what its look like once the acrylic cover is removed..



Hmmm with the background of sunset at Kota Kinabalu Naval Base..



I have plan to engrave the Asus ROG logo maybe at front or top fan cover plus both side of the side panel..so stay tune guys...