first time to help an old lady to solve a myvi door window stuck problem.
passenger side door window failed to raise up even press the window control buttons on both driver side and front passenger side.
it could be lower down by pressing any one of the driver window control button or the passenger side window control button.

unscrewed and opened up the arm rest cover at passenger side, cable wiring seems alright(though no multimeter around to measure the voltage change).

does any one here has this experience and how to solve it?

is it due to mechanical issue or electrical? how to distinguish and troubleshoot?

thank you for any recommendation.

should be cable wire inside the window compartment stuck , since can go up but not down mean 1 side already stuck

Myvi? I thought proton..

Last time I had the same prob. Sometime ok sometime not. At 1st I suspect it is because of the motor. Finally I found out that it is because of the wiring prob. Bad contact. Motor still ok, bo prob.

Just change the car. Just change.

arm bawah bengkok.
although didnt seem bengkok, maybe bengkok enuf to collide with other arm.

it should look like dis

should be electronic /ic controller board on driver site problem....!! ( new controller cost around Rm150~200 + installation )
mine a 8 yr old myvi also having this symptom at driver site...
if only unable to wind up (cos wind down always ok ) just wait a 10~20 sec, then it will be ok again to wind up!!!
me already doing this for more than a year...!!! if u can bare with it.

This post has been edited by pattleongkam: Jun 21 2014, 10:18 AM

Did you lubricate the rubber gasket railing?

I'm had same issue, I used a mix of olive oil and Vaseline. Rub it on the rubber gasket railing.

it could just be the switch.

normally turn off engine then play with the switch and
then turn on engine engine and wind up the window

my car did this last month but the button on the passenger side still able to raise the window up. in the end the accessory shop tauke just replace the control unit (white box) on the driver's side to fix it.

drive plotong..but claimed drive myvi..puih....how dare u..tarnish the glorious myvi's name...the car of god

Ferrari no power window problem

Maybe the contact point in the switch dirty or have some residue on it...just remove and rub with fine grade sand paper...it will solve the problem...happened to my viva b4...

opened and found the wiring inside looks ok, at least tried to move them to the right and spacious area

yes, it becomes sometime working sometime not working now.
when press wind up/down button can hear the "click sound and motor react sound once"
no multimeter around so not sure whether wiring issue or not yet

so kind of you to show the picture. don't know where it located. suspecting the gearing not gear up or motor, really want to verify but don't know where to open to see the gears in your picture, could you guide?

tried winding up after awhile but most of the time(tested 7 times) failed to react. as the car belongs to an old aunty so want to help her to solve it to save her money and keeps her safe in car

where is the rubber gasket railing location? we can do if we can spot it out

looks ok but if got multimeter to verify that will be good
tried, but still the same

the control unit housed in an hard plastic box in driver side, thinking to swap the other window lines to the problematic window lines to verify but need some tools. if it is the control unit, as long as there is a spare one, should have no problem to change, very easy.

the switch condition is quite clean and encapsulation has no damage at all after checked

Just fixed it by replacing a master control switch. Very easy.