Welcome Guest ( Log In | Register )

Outline · [ Standard ] · Linear+

 SPL to SQ, Switching to SQ

views
     
driftmeister
post Aug 12 2006, 05:18 PM

Penggadai Rakyat®
*******
Senior Member
4,133 posts

Joined: Jan 2003
From: Cameron Highlands Rank: Amateur
1 question:
ur front comp is 3 ways ?

if budget permits
change ur 4ch prokick amp
ditch ur rear comps (or change it to power up by HU)
get an active crossover with bandpass (run actively)
change to sealed ( budget style: cover up ur vent)


driftmeister
post Aug 14 2006, 02:31 PM

Penggadai Rakyat®
*******
Senior Member
4,133 posts

Joined: Jan 2003
From: Cameron Highlands Rank: Amateur
reason to change the 4ch prokick - simple.
prokick doesn't give good SQ
high distortion, signal ratio is low, "dirty" sounded

as for sealed box..normally sealed box is smaller...
vented one are normally 1.5cu^ft above

as i said...ditch the rear comp
or make it power up by HU...in SQ setup...
rear comps are just for the ambience
not the sound

and normally the sub are tune low
lower than 100hz depends on the sub's capability
driftmeister
post Aug 18 2006, 05:54 PM

Penggadai Rakyat®
*******
Senior Member
4,133 posts

Joined: Jan 2003
From: Cameron Highlands Rank: Amateur
dun fool by the BB chip in prokick
BB also comes with entry level and high levels
the component they uses is the lowest quality ones
driftmeister
post Aug 22 2006, 07:20 PM

Penggadai Rakyat®
*******
Senior Member
4,133 posts

Joined: Jan 2003
From: Cameron Highlands Rank: Amateur
depends on ur budget rclxms.gif

This post has been edited by driftmeister: Aug 22 2006, 07:21 PM
driftmeister
post Aug 30 2006, 01:00 PM

Penggadai Rakyat®
*******
Senior Member
4,133 posts

Joined: Jan 2003
From: Cameron Highlands Rank: Amateur
3 way is even more complicated in terms of angling, tuning
driftmeister
post Aug 30 2006, 10:01 PM

Penggadai Rakyat®
*******
Senior Member
4,133 posts

Joined: Jan 2003
From: Cameron Highlands Rank: Amateur
H900 can be use as standalone proc

the one which need to pair with 9990 is H990 smile.gif
driftmeister
post Sep 7 2006, 05:25 PM

Penggadai Rakyat®
*******
Senior Member
4,133 posts

Joined: Jan 2003
From: Cameron Highlands Rank: Amateur
to get active for 2 ways

HU-> active crossover-> amps 5/6 channel -> speakers/subs
driftmeister
post Sep 7 2006, 07:57 PM

Penggadai Rakyat®
*******
Senior Member
4,133 posts

Joined: Jan 2003
From: Cameron Highlands Rank: Amateur
3 way external crossover ?

the only crossover that can go 3 way that i can recall is TRU F2
but this is real rare species

but u can forget bout preout cos u HU->Crossover only need 1 pair of RCA

but u're using 1 x 2ch and 1 x4ch
u can only go front 2 way

driftmeister
post Sep 9 2006, 10:39 AM

Penggadai Rakyat®
*******
Senior Member
4,133 posts

Joined: Jan 2003
From: Cameron Highlands Rank: Amateur
QUOTE(GRexer @ Sep 9 2006, 12:54 AM)
Hm... actually there's another crossover that can go 3-way, just that it's lack of exposure, the AudioControl 4XS can actually do 4-way front stage + subwoofer, total 5-pairs of output wink.gif
*
4XS isn't normal analog crossover i reckon?
using chip?
play wit it once and screw up the whole setting tongue.gif tongue.gif tongue.gif

This post has been edited by driftmeister: Sep 9 2006, 10:39 AM

 

Change to:
| Lo-Fi Version
0.0178sec    0.46    7 queries    GZIP Disabled
Time is now: 29th November 2025 - 11:46 AM