i'm subcribe for 30mbps unifi, for a month using dir-850l connection doing great.. but recently, i do some speedtest it only got 7.8mbps... dont know what happen.. connect with tm router, speed reach to 32mbps.. anyone know what happen?

hello, unifi people just recently upgraded my old orange router to DIR 850L (black cylinder dlink router). And I just upgraded to 30mbps. Unfortunately, the signal for this router was bad and when i did some speed test, it's about 7mbps as stated in one of the previous post. Anyone know how to fix this or adjust the router configuration to boost my wifi speed and signal for this Dlink DIR 850L? thanks in advance =)

(my firmware version is 2.07)

you can refer to the following link for the review of the router
http://www.blacktubi.com/review/d-link-dir-850l-review/

I did move to prioritize some of my device in the QOS section.

Can anyone advise the steps to use this router as repeater?

I saw the option is available, you may want to try it.

After set the repeater mode, I think u need to set the same wireless setting same as main router.

Zzzz. Good night

you set 1 in the router and another 1 inside windows, else you will kena block if surf ahem-ahem sites...

really? dunno why this banner keep popping up if set in router...   and also that TM's lazada banner.

my dlink homeplug cant be utilized for hypptv. for internet ok, really good. but for hypptv, nope. i dont know whos at fault here, dlink router or dlink homeplug or the hypptv stb itself. argh..

i'm thinking of downgrading the dlink router (dir 850l) to lower firmware to see if it will make a difference. what do you guys think?

i wonder anyone successfully setup the ddns where they asking for the s/n and mac address of the device? i got the unknown serial number error...

This rounter can't be setup as a vpn server?

Anyone using this router under repeater mode?

May i know you're on which firmware? I was able to switch to repeater mode, but no internet connection

Anybody know how to configure 5 static IP on this router? I tried using the unnumbered IP but when check my public IP still only one IP (shows the router IP not the device IP).