At least at room temperature. Guaranteed way, spray under direct sunlight.

Usually no. I've come across metallic clear coat spray paint, but it was damn expensive and was meant for automotive restoration. If you had a car painting workshop, that would be great

You have not included the shipping charges to Malaysia. Although you would normally still get cheaper price (5-10%) than buying from local retailers, but in the end it roughly amounts up to the same price. Note that this does not apply for P-Bandai exclusives, buying from overseas retailers (Amiami, GGI, HLJ etc) is definitely cheaper.

Same case as ARF, the PG is bulkier than the sleek-looking MG. But in the end we all love it

Well logic dictates that due to the additional frame, not only the mecha but also to its weapons and accessories, they should weight heavier than its HG counterpart, but still not noticeable when you hold it.

There is if you hold them in one hand each, especially Strike Freedom. If you hold them by the legs, RG SF will be tilting back due to its internally-framed wings compared to the hollow HG SF

Actually it is very pose-able, I did some crazy poses before with RG SF. You just need to have patience and

All the MS you mentioned were prominently shown having ground battle, but SF had never had ground battle, that's why action base is a must

Yes it's called Blu Tac. Non permanent like super glue so no damage to the joints.

If the decal was still slippery, that means you didn't drain/absorb the remaining water completely.

Use gundam marker 02, or, get an Artline pen (0.01 size), or mechanical pencil (plus eraser).

Acrylic is the most plastic-friendly, but it is not highly scratch-resistant like enamel.

Very worth it to do so. More satisfaction when you custom paint your gunpla

Press hard and firm, then topcoat the kit.

Go to real art/stationery shop, not those Tesco/Popular/Time

Nope, I meant 0.01. Only two brands I've used before, Artline and Sakura Pigma.

Real stationery or art shops, like near where I work in Publika, there are a few art shops. Likewise, you can also buy them on eBay.

Sinanju and Nu about the same. HiNu is dwarfed by Nu. HiNu is a bit taller than other MG but still noticeably shorter than Nu.

Note that I'm talking about Ver. Ka (all of them).

Tamiya cement.

You should have panel-lined it first before assembling, it'll be PITA afterwards.

Wow Kawaguchi-sensei will be here

This post has been edited by :3mushy:3: Nov 3 2014, 12:53 PM

Depending on the price, I think I might grab the Destiny

Can tumpang Heine Destiny?

You would never know If they had, instant buy