lookin' into the setup, same onli wif mine, diff onli the GFx
wat the highest u can reach currently?

This post has been edited by gengstapo: Aug 11 2006, 03:33 PM

Well, at the moment, NONE!

Not a single MHz can be upped..

err.. have u try running on divider?
or izzit mebi by ur CVS, perhaps other RAMs?

Divider? I have tried all the options, divider, voltage and stuffs. Still, no luck!

My CVS? Perhaps yes, I haven't tried to swap the RAM yet. Should check tonight.

Anyway, I don't really it's RAM, more to my GFX card. Sigh.

owhh, then have u lock the GFx value??

Well, I'll do some thorough check later tonight. Hopefully everything will be fine.

Oh by the way, I got a new board from 1-to-1 exchange. Previous board also facing the same problems, that's why I'm suspecting it's GFX.

hurmmm.. ok then
hoping 2 c ur result later
hope u able to OC ur rig

Did you try with F3 bios?

Yes, I'm on F3 BIOS.

ahh.. how bout F4a??
have u try oso?

dont try f4e.. some killed their bios when flashing their board.

i suggest u to try using other vga card, even pci display card.. and see whether the problem is solve or not..

btw here is my 1st oc with my conroe e6600..

proc at 350x9 @ 3.15ghz

ram at auto (downclock @ ddr700), timing 4-5-4-15 (loose a bit bcoz dont want the ram to hold my cpu oc)

vdimm auto
vmch +0.2
vfsb auto
vpcie auto
vcore 1.375

This post has been edited by irenic: Aug 11 2006, 04:50 PM


Attached thumbnail(s)

hurmm.. higher multi, easy to get 3Ghz!
haizz.. hope i wont change mine in this near future coz wanna grab the ah lian leh

so far no problem for me either F3 or F4C
u can try use pci-e freq 100

This post has been edited by rlhc17: Aug 11 2006, 05:32 PM

buy what u aim for.. jgn mudah terpengaruh!

sure dood.. i wont open this thread until i get my lian li 1st..

Congrats on getting the E6600. With the Vcore changeable, you should try higher

I am here again, now on 3066MHz, FSB @ 438MHz DDR-II 876 CL4-4-4-12 with merely 2.07v.....

No offense to other ppl that do more than 3150MHz, but did you all try to do dual prime SP2004 to ensure the stability? By only running SuperPi or 3DMark or PCMark, enough???

This post has been edited by Austin: Aug 11 2006, 07:01 PM


Attached thumbnail(s)

yups i'll do it after this. rite now my target is to find max stable clockspeed..

i did!





Attached thumbnail(s)

1.35Vcore.. dual super pi 32m pass.. will do dual prime later

451MhzX7.. using 512MBX2 CVS






Sorry duno the result accurate or not... lot of background programs running..

This post has been edited by kev_neville: Aug 11 2006, 08:41 PM

Kev, post 1MB result
But why your screenshot....?