if can... can teach me how to.. coz i look @ bios i dun think there an option there.. anybody with this mobo OCed?

in the main page of the bios press CTRL key together with the F1 key..

It should show you hidden menus

icic.. wahh hidden tactics... btw antonio i got PD 930 3.0ghz normally ppl can OC how fast?

iT depends...sometimes over 4 GHZ sometimes 3.6 oso very hard...but it depends on overall setuip....

antonio i oledi press ctrl + F1 i oledi enabled it.. but when i load the 3dmark03 it cant load into it.



EDIT : can i use the easytune to OC ?

This post has been edited by milky: Jul 29 2006, 09:43 AM

Can also .. since easy tune is mend for Gigabyte series to OC

ic... yesterday i tried from 3.0ghz to 3.3ghz how do i see if my comp can tahan?

use SP2004

open many apps and do 3d mark many times..

guys @ the BIOS i oledi enable the Top Performance.. but when i load the 3dmark05 it can even load into it..

erk..ur system not stable?

guys one more thing ah... bout the easy tune 5.. when i OC until 3.3ghz mean 10% of my default speed. y when i check thru the cpu-z the speeed does not seem stable @ tat 3.30ghz it sumtimes drop from 3.3ghz to 2.7 then 2.8 then 3.0 then back to 3.3 then it fluctuate very frequent

There is no way of easy overclocking! THATS THE RULE.

Using those on-board overclock chip not only can waste your time but could cause a hell lotta trouble later on.

Read more on how to overclock a PC...get to know terms such as raising FSB, increase clock speed, DDR settings and most importantly voltage and temp reading.

Try to get yourself familiar on how to setup those things first. After that only then you can fine tune your computer to its full potential.

And dont forget to lock AGP/PCI or PCIE/PCI

is this the term?
if i OC abit higher cant boot i need to increase the voltage?
does the ram need to make any timing to make the OC or the comp stable?

wat i mean was do i really need to touch the ram section to OC? ccan i jus touch the FSB only?

You need to touch all aspects...remember running your system in a out of spec situation need really fine tuning to avoid damage or faulty error to the software.

Just like a high performance engine, it need the perfect tuning to avoid over-lean which can make ur engine KABOOMM or too rich which can result to higher fuel comsumption...

one more thing i wanted to ask is tat... hmmmm when i convert video & burn cds my proc will speed up to 3.5ghz if nothin is done is will drop till 3.0ghz why is tat happening?

i m using the same mobo on my PD805..i can say this mobo is quite nice..mine nw running at 3.4ghz..still quite stable

hmmm but my proc is D930 woh.. still can ?

can..y not..my D805 also can..ur D930 sure can