Hi all, yesterday I just bought new Thermaltake BigWater SE installed on my system. It seems very hot while full load after overclock my system. It was about 48C!! My room temperature is about 26-28c. I'm pretty sure my water block is installed properly... no bubble on tubing.. anyone can tolong tolong?

AMD Barton 2500+ @ 3200+ 2200MHz
2x Corsair TwinX High Performance 256MB DDR400 2.5-3-3-6
Abit AN7 mobo
ATI 9800SE 256bit 128MB @ 400/700
Creative SoundBlaster Live 5.1
Vtech true power PSU 350watt
1x WD 80GB 8MB 7200rpm ATA100
1x WD 160GB 8MB 7200rpm SATA

aik... then i think my existing TT Silent Tower is better lar.... aiyoooo wasted my money... the temperature almost the same...

i use external to check my thermometer to monitor my cpu temperature. Previously air cooling idle was 43-46c full load was 50-52c. Now water cooling idle 46c full load about the same with air cooling also..
damn!! waste my money

last time i was customade 1 water cooling with Nirox P2800 pump.. i don't think this pump is good enough.. i leave it for testing and the water get warm after an hour.. it was becoz of the pump warm up the water...

I don't think so.. my previous HSF is SilentTower... this TT BigWater SE is much noisy than SilentTower... coz i run full fan speed for the water cooling