didn't plan to install it so far...
some say it allow too much air flow and suffer the engine, not good for long term use...
btw, the k&n filter is oil type? original is paper type?

ya me too...I heard it since the day I fall in love with cars...

I've ask some advice from my uncles (they actually car lovers)

1 of my uncle advice is go ahead with it...somehow all the dirt will become carbon around the engine..
no harm of using it...he is using on his wrx since the 1st day...he say the only problem will occur is the warning check light on mass filter sensor will light on as too many dirt around it and it detected low air flow...he normally clean himself using contact cleaner spray..

my another uncle...not advice due to the reason I stated earlier...large air flow...more dirty flow into engine...

so conclusion...I'll wait and see..

no harm yet no benefit?
mind to explain further?

if oil mix with dust...then ma gg?
the air flow sensor sure affected wor...

Auto Dimming Mirror Installation

http://mazda3revolution.com/forums/2014-ma...iew-mirror.html

got ar...dat SA jason oso provide this for his customer...

ya, he provide free upgrades for his customer..aluminium pedal, auto dimming mirror, door sill plate, reverse camera...

i'm now waiting the auto dimming mirror, reverse camera and front parking sensor...
very difficult for my wife to park the car...the front quite long...

ya, free upgrades...check the previous post...someone has shared it...
what is your packages when you get yours? mind to share?

anyone going to do this?

show pics?

btw, can i use plastidip to spray the rim? is it good for protection?
how do i remove it when i wan it back to original? just peel it of like a skin?

how many layer do you apply? after peel off still have any stain on the rims?
btw, where do you bought it? can share here?

normally with 5 layers, how many can needed for m3 ori rims?
can still get them for me at the same price u have there? how much each u got it?
not really sure how to DIY it...newpaper cover tyre and inner disc break? also body? den just spray it? need to wait it dry only apply another layer?

wow..big project...
i bought 1 can of clear dip to try out...
my lady boss dun allow me for gunmetal or black

guys, i've just dip my rims..
what should i do if there is some part not even? should i peel off the whole rim and respray?

i'm not satisfy with the work done...
i'll redo it again this weekend

at least dashboard not so "plastic"..
civic more to family car while m3 more to driver's car..
u do not have spacious room for rear passenger compare to civic..
i will use "sport sedan" for m3..
smooth gear change for paddle shift compare to civic while i test driving..
hmmm..it's up to your decision, i've pick m3..and i'm not regreting..
and oh ya...i found the leather seat given as a package for m3 is nicer than civic leather seat..
but if for features, m3 will have less features than civic like auto cruise..

This post has been edited by bbball: May 1 2014, 06:41 PM

wow, you take out the whole wheel to spray
i spray 4 layer, but i used 2 can only, how come ya?

then my work considering not normal? i used 2 can..the 2nd can still got half left...how come?
but my whole rims already become matt...i think all surface has been applied besides the inner part..i oni spray the surface...
is it possible because of this?

i'm using clear color actually...from chrome surface become matt now...abit silver color...
i put 4 layer only...cos it looks like very thick already..when touch already got the matt matt feel, very rough surface...
not smooth like original...