Mind to share the link to make the purchase ?

Can you provide the link to your source of reference ?

Why the bottom left and right corners of the screen are not responding at all ?

Was seriously considering this screen protector.

This post has been edited by d3yen: Nov 3 2014, 03:41 AM

I reckon you’re right. I guess installation is crucial in this sense.
Hope they can iron out this issue which will allow more allowance of alignment for installation.

All full coverage screen protectors will have these challenges.
The article that I read mentioned that, only the flat areas of the screen are identical between each iPhones. Whereas the dimensional angle of the curves glass areas have a slight discrepancy between each device, reason being Apple is using different vendors for the supplies.
Hence there is no specific sized protector that will fit each iPhone accurately.
The painted frame is needed to hide the non adhesive bubbles at the curvy borders if such discrepancy arises.

You're welcome

Wow that is really impressive.
Can we still install a rubber case in addition to that for drop protection ?
They mentioned thinness is 0.35mm but unsure that is just for the front piece or total thickness from both sides.

It is not full coverage, where it covers only the flat area of front screen display.
The curved edges are not within coverage.
On the up side, there won’t be any responsiveness issues because the screen protector is in total adhesion with the screen. It may fit most of the cases as well.

I guess so. The spec for the AirMask (iPhone 6) is 139 x 68 x 8mm.
After deducting 6.9mm of the iPhone 6 Depth from the 8mm,
the total thickness from AirMask is around 1.1mm