Hi guys,

A little update..since I already spent to much time on sleeving..

Done installing the EPS cable..



Cut the side of the 5.25 bay to make way for the 6 pin pci-e cable..It's quite time consuming because I only use file to make the hole..broke the dramel during cutting the side panel..





Only manage to get one of the pci-e cable to pass through the hole..



The most hard part is to do the short sata power cable..I manage to put 1 output only because the gap between the two HDDs is too small..the cable won't give in    This one I might need to redo again..



What left to install is the reservoir, 1 sata power cable and 4 pin molex cable for all the other auxiliary needs..