Been buying 3rd party gunplas at high prices. Have a hard time looking for the models i want too I would really appreciate it if someone could PM me a few reliable sellers. Please and thank you.

I buy from those 3rd party shops. bought my Nu. Ka at 135, FA unicorn at 175, Destiny 100, and red frame kai at 100. quite expensive dont you think?

Is that a MG F91???!!!! Holy crap... 21cm is really tall... gotta make space for him >.<

Can anyone tell me where is this shop located? (PM) Looks like there are tons of goodies there. would like to drop by. thank you

Woahh looks promising. Hope they get started on the build fighters season 2 HG kits asap

Finished mine aboit almost 2 months back. Still pending on the decals. Still have alot of unfinished kits. Ver ka. Decals really scare me.... overall, id say its the best Daban kit released. Very solid, not too back heavy, almost perfect snapfitting and good plastic quality. Once youve finished the kit, you'll be very satisfied. Ohh, its pretty HuGE!!!! And here are some of my daban boys.


Attached thumbnail(s)

Its plastic quality is superb. snap fitting too just did some minor recoloring and it looks great. The stickers are a let down though. 3rd party kits are reaching a whole new level

The stickers do adhere really well but the sizing is a tid bit off. Might wanna consider painting the few grey parts if u dont wanna use the stickers. Handle them with care as they tear easily. Decals so far are great

Before i try any ratio of primer:thinner on my kits (B* or bootleg) i always test it on spare parts or runners to make sure that its safe to use. I think u exposed the plastic to wet thinner for too long. Your coating is a little too thick.For my bootleg kits i usually jz use the normal primer spray can by mr hobby. no problems so far.

The condition of your kampfer isnt bad beyond repair. With the right amount of super glue and some sanding on all surfaces of the joints, u can still finish the kit. I used to break some leg joints on bootleg kits when i first started,but managed to repair them. Dont gve up on your kit

where did you get this? how much is it?? looks super portable

I completely agree. I started off my painted build with bootleg kits as i didnt wanna spend much on B* kits incase something goes wrong. Back then i didnt even use any primer but just normal spray cans(non tamiya ones). And i did not have any problems with cracking. I've always sprayed in mist coats. In my opinion, Daban and McModel plastic quality is alot better than GaoGao's. My GaoGao kits tend to break with ease and some got eaten up by paint =.=

Nice work! How do you find the polycaps and plastic quality? Was it hard to get it to stand without falling?

Just finished the Xi gundam. Wasnt as good as expected. Pretty bad weight issues. The DECALS. OMG. Had a freaking difficult time outting them on. The long stripes were HUGE, LONG and they keep getting tangled. Couldve just given dry transfers or marking stickers for some of the decals. However, plastic quality and snap fitting was beyong amazing. Freaking B* level. The end product standing at 21cm tall (abit shorter and smaller then the Nu.Ka) looks great.


Attached thumbnail(s)

This one is without the detachable armor which has similarities to the nu.


Attached thumbnail(s)

Nice work there !!!!! always wanted to get a 2nd Nu Ka.