tictac, what are the temps? And that is Abit KN9 right?
AMDŽ Socket-AM2 Overclocking thread, discuss our setup/overclocking issues
|
|
 Oct 13 2006, 12:32 AM
Return to original view | Post
#1
|
 
Junior Member
359 posts Joined: Mar 2006 From: Kuala Lumpur   
|
|
Quote|
|
|
|
|
Dec 29 2006, 10:03 AM
Return to original view | Post
#2
|
|
Junior Member
359 posts Joined: Mar 2006 From: Kuala Lumpur
|
QUOTE(mr_habuk @ Dec 29 2006, 08:50 AM) guys need help here.. reset cmos jumper (refer to manual) or pull battery out for 5 seconds.playing around with OC feature in M2N-E bios last night, changing multiplier to 8x and set ram timing to 5-5-5-12 n T1.. with 220 frequency.. then it wont reboot..and nothing shown on the monitor..just blank.. and warning beep keep beeping.. how to set it back to default...?  |
|
|
Jan 18 2007, 09:03 PM
Return to original view | Post
#3
|
|
Junior Member
359 posts Joined: Mar 2006 From: Kuala Lumpur
|
QUOTE(syarat @ Jan 17 2007, 08:21 PM) yup.. Typical got no stock response. Funny thing happen yesterday, was looking for ATP3 speaker, one shop gave RM165, the other RM150 from RM168 (on pricelist), usually they are very stingy, then he went to back room for like 2 seconds and say wah today only got sold one. for the time being, hypertx is the best budget coolers.. i saw at MINES IT Centre for RM103..  |
|
|
Jan 19 2007, 08:19 AM
Return to original view | Post
#4
|
|
Junior Member
359 posts Joined: Mar 2006 From: Kuala Lumpur
|
QUOTE(syarat @ Jan 19 2007, 06:58 AM) i said "i saw at rm103".. offftopic: I know la you said nothing about no stocks, I said the shop usually with the same response i didnt write i read a pricelist..the item is inside the acrylic panel maa.. so "no stock" is not applicable here. seriously i was shocked too.   .This post has been edited by seveneleven: Jan 19 2007, 08:29 AM |
|
|
Mar 28 2007, 11:23 AM
Return to original view | Post
#5
|
|
Junior Member
359 posts Joined: Mar 2006 From: Kuala Lumpur
|
Im slow. Brisbane in stores already?
|
|
|
May 3 2007, 10:21 AM
Return to original view | Post
#6
|
|
Junior Member
359 posts Joined: Mar 2006 From: Kuala Lumpur
|
Software reading is not accurate. Use a DMM to check certain points. I've test my tforce 754 and seems almost accurate. 0.01v off maybe due to DMM.
|
|
Topic ClosedOptions
|
| Change to: |  0.0447sec
 0.72
 7 queries
 GZIP Disabled
Time is now: 9th December 2025 - 01:46 PM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.