http://www.amazon.com/gp/aw/d/B00CD1F9XW/r...93066777&sr=8-1

find a spree agent @ Services Noticeboard section.

Hi lucidlts, we are currently waiting for the update as well. 
If you've been following FrostyTech's update for the best AiO Liquid Cooler, you can see that our Nepton 280L scores the best: http://www.frostytech.com/top5_liquid_heatsinks.cfm
Not only that, it received a lot of positive review from famous tech sites such as TweakTown, Tom's Hardware, Overclockers Club and more.

Frosty Tech - http://www.frostytech.com/articleview.cfm?articleid=2752
TweakTown - http://www.tweaktown.com/reviews/5911/cool...view/index.html
Tom's Hardware - http://www.tomshardware.com/reviews/nepton...ax,3607-11.html
Overcockers Club - http://www.overclockersclub.com/reviews/co...er_nepton_280l/
Benchmark Reviews - http://benchmarkreviews.com/8188/cooler-ma...-cooler-review/
Gadgetop - http://gadgetop.com/cooler-master-nepton-2...w/#Introduction

wa, transition to video reviews liao I see

Hi lucidlts, thanks for the brief review on our CM Storm MECH gaming mechanical keyboard. Keep up with the good work

after install jetflo on my seidon 240M
i found out it more noise than blade master with same speed (about 1700RPM) 
well it really high flow than blade master is the greatest 
and the cooling seem still same about 36-42 C in idle mode (may be bcos i got some app still autorun  ) no try full load so donno got how much different

so not sure need any special setup again on it bcos i cant install pull fan on it due put upper HAF X on btm can block motherboard and also cant top due different high.... 

thinking should i remove upper 200mm fan as pull on it or not 

-------------------------------------------------------------------------------------------------------

after check again correct heat, now is 33-39 with idle mode (less than 15% load)
so far the noise still ok bcos it is better than xtraflo 120 red LED (i got try it and it is very loud until need silent mode just can same like other fan noise  )
btw i am not silent build bcos HAF X more prefer for high airflow cooling especially for fan use 

yup i know, but need hear my self juz can know how noise is it 
well for me still ok at least not noise till like engine sound 

btw i forgot say my seidon 240M the radiator some fan hole lock alrdy start loss when i screw it 2nd time for change blade master to Jetflo. donno next time time if i clean the radiator want take out the fan or not  can it cover on warranty? scare next time hard install fan back then got problem......

btw want ask normally pump speed should be how for radiator?
so far i check my 240M run on 1200 rpm for the pump, is it ok on it?

well me connect to board pin and set as standard mode only (with CPU fan), look like the speed pump is fix 1 

but u should got try other liquid cooling before right? are the speed is fix or can adjust? 1st time use not that good 

finally found 1 ppl l share about seidon 240M pump but is in 12V n 7V 

http://www.silentpcreview.com/article1338-page6.html

hi want ask 1 thing, CM Storm no more 5.1 headset except Sirus and Sirus S? 
thinking buy Sirus but found out it dont have volume control for analog jack 
so only Sirus S better for me
but thinking still other choice for me or not 

well i want use 5.1 for my gaming and if can use jack to save more slot for USB 

ehhh this one? http://www.cmstorm.com/en/products/keyboar...CH/&tab=support

or you mean audio passthrough?

my cooler master stuff, so far only CM Storm headset no buy due not any suitable me 
if headset got virtual surround may will think on it 
for now tis is all i have 

well now no money lo 
as i say want go CM set lo so that worth for me 

ya agree
my hyper 212 evo use 3 years still very good
due upgrade then sell to ppl n change to seidon 240m 
btw i try check seidon 240m pump speed max can about 1500 rpm only 

n also my CM Storm set still cant use yet due tis weekend me need clean room n try change all PC stuff position 

well i only know idle is about 33-39C, never try full load b4
got any software can suggest for testing?

ok i have try testing, tis is wat i got but is it correct due no c it 100% load? 



seidon 240m pump speed about 1500 rpm and fan speed about 1700 rpm
i have try testing about 30 min only bcos want c temp

its sad that both are the same design but receive different treatment.. i guess many would want to stay with an optical mouse but with the same braided cables n rubber pads on the Mizar