This post has been edited by wilson26: Aug 1 2015, 11:38 AM
Attached thumbnail(s)
How to choose a good Cooker Hoods & Gas Hobs ?, Kitchen appliances hood / hob / oven
|
|
 Aug 1 2015, 11:22 AM
Return to original view | Post
#1
|
 
Junior Member
253 posts Joined: Jun 2015 
|
hi zheilwane, my house ceiling is quite tall. I'm looking for my kitchen hood paip (mark black rectangle in picture). May I know where can I get the paip or I actually need to replace a whole new hood? thanks.
This post has been edited by wilson26: Aug 1 2015, 11:38 AM Attached thumbnail(s)
|
Quote|
|
|
|
|
Aug 1 2015, 12:13 PM
Return to original view | Post
#2
|
|
Junior Member
253 posts Joined: Jun 2015
|
QUOTE(zheilwane @ Aug 1 2015, 11:44 AM) If you would like to get something better, then change the hood. However, as your ceiling is too high, normal chimnet hood can only reach 8ft ceiling, if any higher you will need to do a box-up to cover it or i know a shop that can customize a longer casing Ic... thanks for the reply... may I know what are the "better" things that I can get by changing the hood? Any good hood that can recommend and what are their price range? Thanks |
|
|
Aug 1 2015, 01:46 PM
Return to original view | Post
#3
|
|
Junior Member
253 posts Joined: Jun 2015
|
QUOTE(idoblu @ Aug 1 2015, 01:24 PM) I think yours is a cabinet recirculating type hood. I used to have one of these hood before. It doesnt have any outlet wan so yes you would need to buy a new one if you want a ducted hood sigh... all these were the ex owner design lar..u r right bro, the stove to hood is too high and it seems unable to suck thing effectively... for the kitchen cabinet that sitting on the floor , ex owner explained to me it's easier to wash and clean the floor... buy maybe he forgot that i have to take out all stuff inside if I want to wash the floor... kind of joker..Usually the cover (the black lines you drew) maximum height is about 900mm to 1000mm. The hood is installed about 650 to 750mm from your counter top. That means from your counter top to your ceiling must not be more than 900+750=1650mm (approximately lah) As I can see from your picture, the stove to hood is like 6,5 ft - Thats too high up and your hood is practically useless to suck anything. Your stove top is way too low lah unless you are a midget  your stove to ceiling is already 3800mm everything is wrong with your kitchen cabinet. How can it be sitting on the floor like that? It should be sitting on legs with a plinth to cover up. My goodness who made your cabinets for you?  Yup was thinking to make legs for the kitchen cabinet to cover up but looks like end up I may need to destroy everything and rebuild my kitchen cabinet.... so now just retain as what the orginally was.. just need to make sure I just mop the kitchen floor without pouring water to clean it...if I need to do so, then I hv to remove stuff inside my the cabinet...  This post has been edited by wilson26: Aug 1 2015, 01:47 PM |
|
|
Aug 18 2015, 10:21 AM
Return to original view | Post
#4
|
|
Junior Member
253 posts Joined: Jun 2015
|
QUOTE(zheilwane @ Aug 2 2015, 06:10 PM) Well, the one you are using is kinda basic, any hood in my shop will b able to do a better job than that Dear Zheilwane If you need more tips or advise, get the measurements of your cabinets. height of ceiling and etc. I could suggest something to solve your problems. Ask to speak to zean since i already seen your cabinet photo and remind me about the issues Sorry for late reply. I've done the measurement as follows: 1) height from feiling to basin is 193cm,=76inch ; 2) width for gas stove (already bought a movable ones but not show in picture) is 92.5cm=36inch ; 3) deep is 59cm,=23inch, 4) tall from marble table to basin is 21cm=8inch Hope to receiving your further comments and advises. Thanks Attached thumbnail(s) 
|
|
|
Aug 18 2015, 06:34 PM
Return to original view | Post
#5
|
|
Junior Member
253 posts Joined: Jun 2015
|
QUOTE(zheilwane @ Aug 18 2015, 02:14 PM) It is possible to install a ducted hood with your measurements. If you are planning to change the tiles, you can remove the old exhaust fan. For hob, if you do not wan to change the table top, just cover it and make it to be the same height as your kitchen sink. by standard, the height of the sink should be 840mm or 33". hi1) I didn't plan to change my tiles so the exhaust fan can just remain there 2) I prefer to change the table top but the problem is can I get the same door replacement as the existing door? Hardware shop got selling this kind of kitchen door? 3) The cover box is a good idea but plaster ceiling I think is not necessary. Could you please send me a quotation for all these including the instalation of a ducted hood ? Thanks |
|
|
Aug 20 2015, 04:24 PM
Return to original view | Post
#6
|
|
Junior Member
253 posts Joined: Jun 2015
|
QUOTE(zheilwane @ Aug 18 2015, 10:06 PM) The door, actually you can get from kitchen cabinet companies, you can PM some of the sellers here in lowyat, check them out in the kitchen cabinet thread. Hi zheilwane, unable to drop by these two weeks due to busy, can pls pm the brochure/ price to me? ThanksFor pricing, you will need to drop by my showroom to select the models according to your preference. DO drop by quick as Rubine and Fotile price will increase next month |
| Change to: |  0.0636sec
 0.69
 8 queries
 GZIP Disabled
Time is now: 2nd December 2025 - 08:43 AM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.