Agree. Mitsubishi have a best easy clean aircon. Specially the blower side. Why others brand can't design something like Mitsubishi? 

It take time to dismantle the flip and clean the blower. Difficult to reach the blower also. 

I will get the Mitsubishi aircon for my next change.

hmm... called the dealer... all quoted rm1650 much more expensive than daikin and york... i mean the 1HP Mitsubishi inverter

Wah.. This simple easy cleaning also ME trademark liau?

panasonic then,
i do comparision between EER for few brand below already
Hitachi 12.80
Panasonic 12.56
Daikin 12.14
York 11.66
Mitsubishi 11.08
which means hitachi more electric saving (assuming all used in same condition and hour and etc)

sharp and panasonic any good ? my place limited option for other brands

panasonic then,
i do comparision between EER for few brand below already
Hitachi 12.80
Panasonic 12.56
Daikin 12.14
York 11.66
Mitsubishi 11.08
which means hitachi more electric saving (assuming all used in same condition and hour and etc)

Wooohooo.. installed my 1st air cond brand Daikin R410a !! lolz...
the compressor damn big... bigger than Panasonic which my neighbour have it...

oh i see, it will indicate to tell u to replace filter?

I think it has nothing to do with the gas. It just that daikin preset their unit to start the outdoor unit a few seconds late than the indoor unit. Once the outdoor unit start to kickin, the cooling is instantanous. Wonder why?

bro freestyler

how come the numbers are different?

dude it suppose to be different what... what kind of question u asked ? =.=
go read SEER rating.. and how to calculate
huh? dont understand u..
i tested yesterday night... with 25 degree... comfortable level.. dont owned a R22 before so i dont know R22 cooler or R410a

My neighbor all using Daikin R22 inverter, Her living room are cold, and running everyday.Visit her house during Deepavali with lots of guest.
R22 or R410A nothing to do cold or not, it maybe a faulty on the A/C, nothing to do with the gas.

oh my bad... actually i do 2 time of calculation

as u know inverter there are variable power / btu output..
the 1st one i calculate using the MAX power
and for the 2nd i calculate at the spec btu output..
to make it clear example as below:-

Daikin 1 HP R410a

btu/h 8,500 (4,100 - 10,900)
power consumption 0.70 (0.30 - 1.05)
1st calculation 10,900 divide by 1050Watt = 10.38 EER
2nd calculation 8500 divide by 700Watt =12.14 EER

so this is how i calculate.. i estimate the maximum and the recommended btu/h to see which 1 is the most high EER =)
thus power saving 

np glad to help haha...

by the way, who using R410a Daikin 1 HP?

kinda confuse with the function

1) the Dry Mode... what its for? means like normal fan only without cooling?
2) the mould proof function.. how to use it?
and daikin compressor damn big man.. lolz

well, for the 1st time user the only thing can compare is through the spec... i wish can test run all the brand in my room for a week before purchase... HAHAHAH !

err shit..i didnt ask that... by the way what is drain plate?
i know how to remove the filter to clean..

Anyone know what is air-con pump?

High pressure does not mean good. R410A need to be operate at higher pressure because of the gas nature. The older R11 & R12 are much more better gas to use in term of efficiency but not environment and the it run same pressure like R22 (If my remember correctly). How efficiency also depend on how the liquid/gas transfer heat.

Just like olden day, the brake pads are so much better, last longer and cheaper when Asbestos are use to made pad, but due to environment and health hazard is ban, and not a good brake pad either need metalic compound or it finish up fast.

Due to my condo layout, my air-con guys said each of the air-con need to attach with a small pump,
so the drip water is 'powerful' and route to balcony from master room

after i read through the installation manual i found out my installer didnt do 1 thing... in the manual mention the Liquid and Gas Pipe should be separately insulate , but my installer insulate it together...

T_T