Need Help: How to remove the broken steel pipe?, SOLVED!!
|
|
 Nov 25 2013, 08:23 PM
Return to original view | Post
#1
|
 
Senior Member
3,076 posts Joined: Jan 2008  
|
I kena before. I used a metal saw blade to saw the inner side of the broken pipe. Saw at 3 different locations. After that use a flat head screw driver to korek it so that it breaks into pieces. If cannot break, saw deeper. Note: do not saw until you spoil the thread of the good pipe.
|
|
|
|
|
|
Nov 25 2013, 08:33 PM
Return to original view | Post
#2
|
|
Senior Member
3,076 posts Joined: Jan 2008
|
QUOTE(bsb85my @ Nov 25 2013, 08:28 PM) But even you saw, you will still saw through the thread. Because you'll need to cut the broke pipe until the end. End up the thread will be have 3 lines there. Correct me if i'm wrong. You don't saw until the thread of the broken pipe. Saw until you can break it into pieces with a flat head screwdriver.  Saw and korek, saw and korek until it breaks. |
|
|
Nov 25 2013, 10:24 PM
Return to original view | Post
#3
|
|
Senior Member
3,076 posts Joined: Jan 2008
|
These extractors are mainly used to remove broken screws. I don't think you can use them on a hollow pipe. Especially the hollow pipe has a big hole.
|
|
|
Nov 26 2013, 08:34 AM
Return to original view | Post
#4
|
|
Senior Member
3,076 posts Joined: Jan 2008
|
Glad that you managed to get the broken piece out and installed a new tap.
|
| Change to: |  0.1247sec
 1.14
 7 queries
 GZIP Disabled
Time is now: 19th December 2025 - 07:51 PM |
Quote